ide-disk: workaround for buggy HPA support on ST340823A (take 3)

This disk reports total number of sectors instead of maximum sector address
in response to READ_NATIVE_MAX_ADDRESS command and also happily accepts
SET_MAX_ADDRESS command with the bogus value.  This results in +1 sector
capacity being used and errors on attempts to use the last sector.

...
hdd: Host Protected Area detected.
        current capacity is 78165360 sectors (40020 MB)
        native  capacity is 78165361 sectors (40020 MB)
hdd: Host Protected Area disabled.
...
hdd: reading: block=78165360, sectors=1, buffer=0xc1e63000
hdd: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hdd: dma_intr: error=0x10 { SectorIdNotFound }, LBAsect=78165360, sector=78165360
...

Add hpa_list[] table and workaround the issue in idedisk_check_hpa().

v2:
* Add missing export and improve patch description a bit.

v3:
* Add list termination.  (From Mikko)

Fixes kernel bugzilla bug #8816.

Thanks to Mikko for investigating the issue and helping with this patch.

Cc: Mikko Rapeli <mikko.rapeli@iki.fi>
Cc: Alan Cox <alan@lxorguk.ukuu.org.uk>
Signed-off-by: NBartlomiej Zolnierkiewicz <bzolnier@gmail.com>

drivers/ide/ide-disk.c

@@ -481,6 +481,15 @@ static inline int idedisk_supports_lba48(const struct hd_driveid *id)
 	       && id->lba_capacity_2;
 }
 
+/*
+ * Some disks report total number of sectors instead of
+ * maximum sector address.  We list them here.
+ */
+static const struct drive_list_entry hpa_list[] = {
+	{ "ST340823A",	NULL },
+	{ NULL,		NULL }
+};
+
 static void idedisk_check_hpa(ide_drive_t *drive)
 {
 	unsigned long long capacity, set_max;
@@ -492,6 +501,15 @@ static void idedisk_check_hpa(ide_drive_t *drive)
 	else
 		set_max = idedisk_read_native_max_address(drive);
 
+	if (ide_in_drive_list(drive->id, hpa_list)) {
+		/*
+		 * Since we are inclusive wrt to firmware revisions do this
+		 * extra check and apply the workaround only when needed.
+		 */
+		if (set_max == capacity + 1)
+			set_max--;
+	}
+
 	if (set_max <= capacity)
 		return;
 

drivers/ide/ide-iops.c

@@ -584,6 +584,8 @@ int ide_in_drive_list(struct hd_driveid *id, const struct drive_list_entry *driv
 	return 0;
 }
 
+EXPORT_SYMBOL_GPL(ide_in_drive_list);
+
 /*
  * Early UDMA66 devices don't set bit14 to 1, only bit13 is valid.
  * We list them here and depend on the device side cable detection for them.