提交 aeebe84c 编写于 作者: Y Yinghai Lu 提交者: H. Peter Anvin

x86, mm: Use big page size for small memory range

We could map small range in the middle of big range at first, so should use
big page size at first to avoid using small page size to break down page table.

Only can set big page bit when that range has ram area around it.

-v2: fix 32bit boundary checking. We can not count ram above max_low_pfn
	for 32 bit.
Signed-off-by: NYinghai Lu <yinghai@kernel.org>
Link: http://lkml.kernel.org/r/1353123563-3103-19-git-send-email-yinghai@kernel.orgSigned-off-by: NH. Peter Anvin <hpa@linux.intel.com>
上级 960ddb4f
......@@ -88,6 +88,40 @@ static int __meminit save_mr(struct map_range *mr, int nr_range,
return nr_range;
}
/*
* adjust the page_size_mask for small range to go with
* big page size instead small one if nearby are ram too.
*/
static void __init_refok adjust_range_page_size_mask(struct map_range *mr,
int nr_range)
{
int i;
for (i = 0; i < nr_range; i++) {
if ((page_size_mask & (1<<PG_LEVEL_2M)) &&
!(mr[i].page_size_mask & (1<<PG_LEVEL_2M))) {
unsigned long start = round_down(mr[i].start, PMD_SIZE);
unsigned long end = round_up(mr[i].end, PMD_SIZE);
#ifdef CONFIG_X86_32
if ((end >> PAGE_SHIFT) > max_low_pfn)
continue;
#endif
if (memblock_is_region_memory(start, end - start))
mr[i].page_size_mask |= 1<<PG_LEVEL_2M;
}
if ((page_size_mask & (1<<PG_LEVEL_1G)) &&
!(mr[i].page_size_mask & (1<<PG_LEVEL_1G))) {
unsigned long start = round_down(mr[i].start, PUD_SIZE);
unsigned long end = round_up(mr[i].end, PUD_SIZE);
if (memblock_is_region_memory(start, end - start))
mr[i].page_size_mask |= 1<<PG_LEVEL_1G;
}
}
}
static int __meminit split_mem_range(struct map_range *mr, int nr_range,
unsigned long start,
unsigned long end)
......@@ -182,6 +216,9 @@ static int __meminit split_mem_range(struct map_range *mr, int nr_range,
nr_range--;
}
if (!after_bootmem)
adjust_range_page_size_mask(mr, nr_range);
for (i = 0; i < nr_range; i++)
printk(KERN_DEBUG " [mem %#010lx-%#010lx] page %s\n",
mr[i].start, mr[i].end - 1,
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册