提交 ae9c25a1 编写于 作者: F Felix Fietkau 提交者: John W. Linville

ath9k_hw: do not lower ANI setting below default on AR913x

When the amount of noise fluctuates strongly, low immunity settings
can sometimes disrupt signal detection on AR913x chips. When that
happens, no OFDM/CCK errors are reported anymore, and ANI tunes the
radio to the lowest immunity settings.
Usually rx/tx fails as well in that case.

To fix this, keep noise immunity settings at or above ANI default level,
which will keep radio parameters at or above INI values.
Signed-off-by: NFelix Fietkau <nbd@openwrt.org>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
上级 38f3106a
......@@ -155,6 +155,9 @@ static void ath9k_hw_set_ofdm_nil(struct ath_hw *ah, u8 immunityLevel,
ATH9K_ANI_RSSI_THR_LOW,
ATH9K_ANI_RSSI_THR_HIGH);
if (AR_SREV_9100(ah) && immunityLevel < ATH9K_ANI_OFDM_DEF_LEVEL)
immunityLevel = ATH9K_ANI_OFDM_DEF_LEVEL;
if (!scan)
aniState->ofdmNoiseImmunityLevel = immunityLevel;
......@@ -235,6 +238,9 @@ static void ath9k_hw_set_cck_nil(struct ath_hw *ah, u_int8_t immunityLevel,
BEACON_RSSI(ah), ATH9K_ANI_RSSI_THR_LOW,
ATH9K_ANI_RSSI_THR_HIGH);
if (AR_SREV_9100(ah) && immunityLevel < ATH9K_ANI_CCK_DEF_LEVEL)
immunityLevel = ATH9K_ANI_CCK_DEF_LEVEL;
if (ah->opmode == NL80211_IFTYPE_STATION &&
BEACON_RSSI(ah) <= ATH9K_ANI_RSSI_THR_LOW &&
immunityLevel > ATH9K_ANI_CCK_MAX_LEVEL_LOW_RSSI)
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册