lantiq: Move the Lantiq SoC driver

Move the Lantiq driver into drivers/net/ethernet/ and the
necessary Kconfig and Makefile changes.

CC: John Crispin <blogic@openwrt.org>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Acked-by: NJohn Crispin <blogic@openwrt.org>

drivers/net/Kconfig

@@ -478,12 +478,6 @@ config NET_POCKET
 	  the questions about this class of network devices. If you say Y, you
 	  will be asked for your specific device in the following questions.
 
-config LANTIQ_ETOP
-	tristate "Lantiq SoC ETOP driver"
-	depends on SOC_TYPE_XWAY
-	help
-	  Support for the MII0 inside the Lantiq SoC
-
 endif # NET_ETHERNET
 
 #

drivers/net/Makefile

@@ -62,7 +62,6 @@ obj-$(CONFIG_DM9000) += dm9000.o
 obj-$(CONFIG_ENC28J60) += enc28j60.o
 obj-$(CONFIG_ETHOC) += ethoc.o
 obj-$(CONFIG_GRETH) += greth.o
-obj-$(CONFIG_LANTIQ_ETOP) += lantiq_etop.o
 
 obj-$(CONFIG_DNET) += dnet.o
 obj-$(CONFIG_MACB) += macb.o

drivers/net/ethernet/Kconfig

@@ -52,6 +52,12 @@ config KORINA
 	  If you have a Mikrotik RouterBoard 500 or IDT RC32434
 	  based system say Y. Otherwise say N.
 
+config LANTIQ_ETOP
+	tristate "Lantiq SoC ETOP driver"
+	depends on SOC_TYPE_XWAY
+	---help---
+	  Support for the MII0 inside the Lantiq SoC
+
 source "drivers/net/ethernet/marvell/Kconfig"
 source "drivers/net/ethernet/mellanox/Kconfig"
 source "drivers/net/ethernet/micrel/Kconfig"

drivers/net/ethernet/Makefile

@@ -26,6 +26,7 @@ obj-$(CONFIG_NET_VENDOR_XSCALE) += xscale/
 obj-$(CONFIG_IP1000) += icplus/
 obj-$(CONFIG_JME) += jme.o
 obj-$(CONFIG_KORINA) += korina.o
+obj-$(CONFIG_LANTIQ_ETOP) += lantiq_etop.o
 obj-$(CONFIG_NET_VENDOR_MARVELL) += marvell/
 obj-$(CONFIG_NET_VENDOR_MELLANOX) += mellanox/
 obj-$(CONFIG_NET_VENDOR_MICREL) += micrel/