qla2xxx: prevent board_disable from running during EEH

Commit f3ddac19 ("[SCSI] qla2xxx:
Disable adapter when we encounter a PCI disconnect.") has introduced a
code that disables the board, releasing some resources, when reading
0xffffffff.

In case this happens when there is an EEH, this read will trigger EEH
detection and set PCI channel offline. EEH will be able to recover the
card from this state by doing a reset, so it's a better option than
simply disabling the card.

Since eeh_check_failure will mark the channel as offline before
returning the read value, in case there really was an EEH, we can simply
check for pci_channel_offline, preventing the board_disable code from
running if it's true.

Without this patch, EEH code will try to access those same resources
that board_disable will try to free. This race can cause EEH recovery to
fail.

[  504.370577] EEH: Notify device driver to resume
[  504.370580] qla2xxx [0001:07:00.0]-9002:2: The device failed to resume I/O from slot/link_reset.
Signed-off-by: NThadeu Lima de Souza Cascardo <cascardo@linux.vnet.ibm.com>
Acked-by: NHimanshu Madhani <himanshu.madhani@qlogic.com>
Signed-off-by: NJames Bottomley <JBottomley@Odin.com>

drivers/scsi/qla2xxx/qla_isr.c

@@ -116,7 +116,7 @@ bool
 qla2x00_check_reg32_for_disconnect(scsi_qla_host_t *vha, uint32_t reg)
 {
 	/* Check for PCI disconnection */
-	if (reg == 0xffffffff) {
+	if (reg == 0xffffffff && !pci_channel_offline(vha->hw->pdev)) {
 		if (!test_and_set_bit(PFLG_DISCONNECTED, &vha->pci_flags) &&
 		    !test_bit(PFLG_DRIVER_REMOVING, &vha->pci_flags) &&
 		    !test_bit(PFLG_DRIVER_PROBING, &vha->pci_flags)) {