ath6kl: deinitialise wiphy on error

This fixes the following panic observed on card removal.

BUG: unable to handle kernel paging request at f86e22ac
EIP is at wiphy_update_regulatory+0x252/0x590 [cfg80211]
Call Trace:
 [<f92fb9e5>] set_regdom+0x165/0x600 [cfg80211]
 [<c02057ba>] ? __kmalloc+0x10a/0x190
 [<c0366557>] ? nla_parse+0xb7/0xd0
 [<f9300b92>] ? T.1400+0x12/0x20 [cfg80211]
 [<f9300c84>] nl80211_set_reg+0xe4/0x270 [cfg80211]
 [<f92fe560>] ? nl80211_pre_doit+0x0/0x160 [cfg80211]
 [<c050bdeb>] genl_rcv_msg+0x23b/0x280
 [<c050bbb0>] ? genl_rcv_msg+0x0/0x280
 [<c050ab76>] netlink_rcv_skb+0x86/0xb0
 [<c050bb80>] ? genl_rcv+0x0/0x30
 [<c050bb9c>] genl_rcv+0x1c/0x30
Signed-off-by: NVivek Natarajan <nataraja@qca.qualcomm.com>
Signed-off-by: NKalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath6kl/sdio.c

@@ -25,6 +25,7 @@
 #include "hif-ops.h"
 #include "target.h"
 #include "debug.h"
+#include "cfg80211.h"
 
 struct ath6kl_sdio {
 	struct sdio_func *func;
@@ -816,7 +817,7 @@ static int ath6kl_sdio_probe(struct sdio_func *func,
 			ath6kl_err("Failed to enable 4-bit async irq mode %d\n",
 				   ret);
 			sdio_release_host(func);
-			goto err_dma;
+			goto err_cfg80211;
 		}
 
 		ath6kl_dbg(ATH6KL_DBG_TRC, "4-bit async irq mode enabled\n");
@@ -829,7 +830,7 @@ static int ath6kl_sdio_probe(struct sdio_func *func,
 
 	ret = ath6kl_sdio_power_on(ar_sdio);
 	if (ret)
-		goto err_dma;
+		goto err_cfg80211;
 
 	sdio_claim_host(func);
 
@@ -853,6 +854,8 @@ static int ath6kl_sdio_probe(struct sdio_func *func,
 
 err_off:
 	ath6kl_sdio_power_off(ar_sdio);
+err_cfg80211:
+	ath6kl_cfg80211_deinit(ar_sdio->ar);
 err_dma:
 	kfree(ar_sdio->dma_buffer);
 err_hif: