iwlwifi: pcie: Set scheduler to work on auto mode

During NIC initialization shared HW is reset and this disables the
scheduler. Some HW platforms do not activate the scheduler after it.
Consequently all HCMD sent by the driver stay at the queues which cause
to queue stuck.
Set the scheduler to work on auto active mode so it would be activated upon
change over one of the queues' write pointer.
Signed-off-by: NHaim Dreyfuss <haim.dreyfuss@intel.com>
Signed-off-by: NEmmanuel Grumbach <emmanuel.grumbach@intel.com>

drivers/net/wireless/iwlwifi/iwl-prph.h

@@ -253,6 +253,7 @@
 #define SCD_QUEUE_CTX_REG2_FRAME_LIMIT_POS	(16)
 #define SCD_QUEUE_CTX_REG2_FRAME_LIMIT_MSK	(0x007F0000)
 #define SCD_GP_CTRL_ENABLE_31_QUEUES		BIT(0)
+#define SCD_GP_CTRL_AUTO_ACTIVE_MODE		BIT(18)
 
 /* Context Data */
 #define SCD_CONTEXT_MEM_LOWER_BOUND	(SCD_MEM_LOWER_BOUND + 0x600)

drivers/net/wireless/iwlwifi/pcie/tx.c

@@ -915,6 +915,7 @@ int iwl_pcie_tx_init(struct iwl_trans *trans)
 		}
 	}
 
+	iwl_set_bits_prph(trans, SCD_GP_CTRL, SCD_GP_CTRL_AUTO_ACTIVE_MODE);
 	if (trans->cfg->base_params->num_of_queues > 20)
 		iwl_set_bits_prph(trans, SCD_GP_CTRL,
 				  SCD_GP_CTRL_ENABLE_31_QUEUES);