gpio: gpio-it87: Add support for IT8620 and IT8628

These chips seem to have a 9th GPIO block (thus supporting 72 GPIOs)
which is configured through SuperIO register 0xd2 (output enable) and
0xd3 (simple I/O). This is also the reason why io_size is larger than
on IT8728 / IT8732. Unfortunately I don't have hardware to test this 9th
GPIO block.

I am also not sure about not configuring the Simple I/O registers as the
hardware I have only uses GPIO block 8. Reading back the values of
0xc0-0xc7 (as configured by the BIOS/EFI on my board) shows that all
have 0xff set.
Signed-off-by: NMartin Blumenstingl <martin.blumenstingl@googlemail.com>
Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>

drivers/gpio/Kconfig

@@ -558,7 +558,7 @@ config GPIO_IT87
 	  Say yes here to support GPIO functionality of IT87xx Super I/O chips.
 
 	  This driver is tested with ITE IT8728 and IT8732 Super I/O chips, and
-	  supports the IT8761E Super I/O chip as well.
+	  supports the IT8761E, IT8620E and IT8628E Super I/O chip as well.
 
 	  To compile this driver as a module, choose M here: the module will
 	  be called gpio_it87

drivers/gpio/gpio-it87.c

@@ -34,6 +34,8 @@
 
 /* Chip Id numbers */
 #define NO_DEV_ID	0xffff
+#define IT8620_ID	0x8620
+#define IT8628_ID	0x8628
 #define IT8728_ID	0x8728
 #define IT8732_ID	0x8732
 #define IT8761_ID	0x8761
@@ -302,6 +304,14 @@ static int __init it87_gpio_init(void)
 	it87_gpio->chip = it87_template_chip;
 
 	switch (chip_type) {
+	case IT8620_ID:
+	case IT8628_ID:
+		gpio_ba_reg = 0x62;
+		it87_gpio->io_size = 11;
+		it87_gpio->output_base = 0xc8;
+		it87_gpio->simple_size = 0;
+		it87_gpio->chip.ngpio = 64;
+		break;
 	case IT8728_ID:
 	case IT8732_ID:
 		gpio_ba_reg = 0x62;