[POWERPC] Fix MPC5200 (not B!) device tree so FEC ethernet works

This gets the FEC ethernet driver working again on the lite5200
platform.

The FEC driver is also compatible with the MPC5200, not only with the
MPC5200B, so this adds a suitable entry to the driver's match list.
Furthermore this adds the settings for the PHY in the dts file for the
Lite5200.  Note, that this is not exactly the same as in the
Lite5200B, because the PHY is located at f0003000:01 for the 5200, and
at :00 for the 5200B.  This was tested on a Lite5200 and a Lite5200B,
both booted a kernel via tftp and mounted the root via nfs
successfully.
Signed-off-by: NRené Bürgel <r.buergel@unicontrol.de>
Acked-by: NGrant Likely <grant.likely@secretlab.ca>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

arch/powerpc/boot/dts/lite5200.dts

@@ -258,6 +258,21 @@
 			local-mac-address = [ 00 00 00 00 00 00 ];
 			interrupts = <2 5 0>;
 			interrupt-parent = <&mpc5200_pic>;
+			phy-handle = <&phy0>;
+		};
+
+		mdio@3000 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			compatible = "fsl,mpc5200-mdio";
+			reg = <3000 400>;	// fec range, since we need to setup fec interrupts
+			interrupts = <2 5 0>;	// these are for "mii command finished", not link changes & co.
+			interrupt-parent = <&mpc5200_pic>;
+
+			phy0:ethernet-phy@1 {
+				device_type = "ethernet-phy";
+				reg = <1>;
+			};
 		};
 
 		ata@3a00 {

drivers/net/fec_mpc52xx.c

@@ -1057,6 +1057,7 @@ static int mpc52xx_fec_of_resume(struct of_device *op)
 #endif
 
 static struct of_device_id mpc52xx_fec_match[] = {
+	{ .type = "network", .compatible = "fsl,mpc5200b-fec", },
 	{ .type = "network", .compatible = "fsl,mpc5200-fec", },
 	{ .type = "network", .compatible = "mpc5200-fec", },
 	{ }

drivers/net/fec_mpc52xx_phy.c

@@ -179,6 +179,7 @@ static int mpc52xx_fec_mdio_remove(struct of_device *of)
 
 static struct of_device_id mpc52xx_fec_mdio_match[] = {
 	{ .compatible = "fsl,mpc5200b-mdio", },
+	{ .compatible = "fsl,mpc5200-mdio", },
 	{ .compatible = "mpc5200b-fec-phy", },
 	{}
 };