thermal: armada: Change sensors trim default value

Errata #132698 highlights an error in the default value of Tc trim.
Set this parameter to b'011.
Suggested-by: NDavid Sniatkiwicz <davidsn@marvell.com>
Signed-off-by: NMiquel Raynal <miquel.raynal@free-electrons.com>
Reviewed-by: NGregory CLEMENT <gregory.clement@free-electrons.com>
Signed-off-by: NEduardo Valentin <edubezval@gmail.com>

drivers/thermal/armada_thermal.c

@@ -46,6 +46,10 @@
 #define CONTROL0_OFFSET			0x0
 #define CONTROL1_OFFSET			0x4
 
+/* Errata fields */
+#define CONTROL0_TSEN_TC_TRIM_MASK	0x7
+#define CONTROL0_TSEN_TC_TRIM_VAL	0x3
+
 /* TSEN refers to the temperature sensors within the AP */
 #define CONTROL0_TSEN_START		BIT(0)
 #define CONTROL0_TSEN_RESET		BIT(1)
@@ -161,6 +165,15 @@ static void armada380_init_sensor(struct platform_device *pdev,
 	reg &= ~CONTROL1_EXT_TSEN_SW_RESET;
 	writel(reg, priv->control1);
 	msleep(10);
+
+	/* Set Tsen Tc Trim to correct default value (errata #132698) */
+	if (priv->control0) {
+		reg = readl_relaxed(priv->control0);
+		reg &= ~CONTROL0_TSEN_TC_TRIM_MASK;
+		reg |= CONTROL0_TSEN_TC_TRIM_VAL;
+		writel(reg, priv->control0);
+		msleep(10);
+	}
 }
 
 static void armada_ap806_init_sensor(struct platform_device *pdev,