net: add calxeda xgmac ethernet driver

Add support for the XGMAC 10Gb ethernet device in the Calxeda Highbank
SOC.
Signed-off-by: NRob Herring <rob.herring@calxeda.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Documentation/devicetree/bindings/net/calxeda-xgmac.txt

+* Calxeda Highbank 10Gb XGMAC Ethernet
+
+Required properties:
+- compatible : Should be "calxeda,hb-xgmac"
+- reg : Address and length of the register set for the device
+- interrupts : Should contain 3 xgmac interrupts. The 1st is main interrupt.
+  The 2nd is pwr mgt interrupt. The 3rd is low power state interrupt.
+
+Example:
+
+ethernet@fff50000 {
+        compatible = "calxeda,hb-xgmac";
+        reg = <0xfff50000 0x1000>;
+        interrupts = <0 77 4  0 78 4  0 79 4>;
+};

drivers/net/ethernet/Kconfig

@@ -28,6 +28,7 @@ source "drivers/net/ethernet/cadence/Kconfig"
 source "drivers/net/ethernet/adi/Kconfig"
 source "drivers/net/ethernet/broadcom/Kconfig"
 source "drivers/net/ethernet/brocade/Kconfig"
+source "drivers/net/ethernet/calxeda/Kconfig"
 source "drivers/net/ethernet/chelsio/Kconfig"
 source "drivers/net/ethernet/cirrus/Kconfig"
 source "drivers/net/ethernet/cisco/Kconfig"

drivers/net/ethernet/Makefile

@@ -14,6 +14,7 @@ obj-$(CONFIG_NET_ATMEL) += cadence/
 obj-$(CONFIG_NET_BFIN) += adi/
 obj-$(CONFIG_NET_VENDOR_BROADCOM) += broadcom/
 obj-$(CONFIG_NET_VENDOR_BROCADE) += brocade/
+obj-$(CONFIG_NET_CALXEDA_XGMAC) += calxeda/
 obj-$(CONFIG_NET_VENDOR_CHELSIO) += chelsio/
 obj-$(CONFIG_NET_VENDOR_CIRRUS) += cirrus/
 obj-$(CONFIG_NET_VENDOR_CISCO) += cisco/

drivers/net/ethernet/calxeda/Kconfig

+config NET_CALXEDA_XGMAC
+	tristate "Calxeda 1G/10G XGMAC Ethernet driver"
+
+	select CRC32
+	help
+	  This is the driver for the XGMAC Ethernet IP block found on Calxeda
+	  Highbank platforms.

drivers/net/ethernet/calxeda/Makefile

+obj-$(CONFIG_NET_CALXEDA_XGMAC) += xgmac.o