arm64: mm: report unhandled level-0 translation faults correctly

Translation faults that occur due to the input address being outside
of the address range mapped by the relevant base register are reported
as level 0 faults in ESR.DFSC.

If the faulting access cannot be resolved by the kernel (e.g. because
it is not mapped by a vma), then we report "input address range fault"
on the console. This was fine until we added support for 48-bit VAs,
which actually place PGDs at level 0 and can trigger faults for invalid
addresses that are within the range of the page tables.

This patch changes the string to report "level 0 translation fault",
which is far less confusing.
Signed-off-by: NWill Deacon <will.deacon@arm.com>

arch/arm64/mm/fault.c

@@ -380,7 +380,7 @@ static struct fault_info {
 	{ do_bad,		SIGBUS,  0,		"level 1 address size fault"	},
 	{ do_bad,		SIGBUS,  0,		"level 2 address size fault"	},
 	{ do_bad,		SIGBUS,  0,		"level 3 address size fault"	},
-	{ do_translation_fault,	SIGSEGV, SEGV_MAPERR,	"input address range fault"	},
+	{ do_translation_fault,	SIGSEGV, SEGV_MAPERR,	"level 0 translation fault"	},
 	{ do_translation_fault,	SIGSEGV, SEGV_MAPERR,	"level 1 translation fault"	},
 	{ do_translation_fault,	SIGSEGV, SEGV_MAPERR,	"level 2 translation fault"	},
 	{ do_page_fault,	SIGSEGV, SEGV_MAPERR,	"level 3 translation fault"	},