tty: msm_serial: remove static clk rate setting in probe

The issue with setting up a fixed clock rate at probe is that it would
overwrite the console rate set by the bootloader for its console device.
This would result in serial out corruption or missing log when we system
is booted with earlycon. This is not a issue if we boot system without
earlycon.

This setup is at least not required with the mainline driver, this code
used to be required because the clk_enable() call would fail if
clk_set_rate() wasn't called first.

Originally the issue was noticed on DB410c which is based on APQ8016
chipset.

Without this patch the console log with earlycon would look like:
...
[    0.000000] RCU: Adjusting geometry for rcu_fanout_leaf=64, nr_cpu_ids=1
[    0.000000] NR_IRQS:64 nr_irqs:64 0
����+HH��0.699378] console [ttyMSM0] enabled
[    0.699378] console [ttyMSM0] enabled
[    0.702003] bootconsole [uart0] disabled
[    0.702003] bootconsole [uart0] disabled
...

with this patch I can see all the skipped lines on the console
Reviewed-by: NStephen Boyd <sboyd@codeaurora.org>
Signed-off-by: NSrinivas Kandagatla <srinivas.kandagatla@linaro.org>
Acked-by: NAndy Gross <andy.gross@linaro.org>
Tested-by: NPramod Gurav <gpramod@codeaurora.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/msm_serial.c

@@ -1577,8 +1577,6 @@ static int msm_serial_probe(struct platform_device *pdev)
 		msm_port->pclk = devm_clk_get(&pdev->dev, "iface");
 		if (IS_ERR(msm_port->pclk))
 			return PTR_ERR(msm_port->pclk);
-
-		clk_set_rate(msm_port->clk, 1843200);
 	}
 
 	port->uartclk = clk_get_rate(msm_port->clk);