提交 753621c2 编写于 作者: P Peter Ujfalusi

ASoC: twl6040: Configure PLL only once

Avoid configuring the PLL several times during audio startup.
We can configure the PLL at prepare time with parameters collected
earlier hw_param, and set_dai_sysclk calls.
Signed-off-by: NPeter Ujfalusi <peter.ujfalusi@ti.com>
Acked-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
上级 f53c346c
......@@ -1343,9 +1343,6 @@ static int twl6040_set_bias_level(struct snd_soc_codec *codec,
break;
}
/* get PLL and sysclk after power transition */
priv->pll = twl6040_get_pll(twl6040);
priv->sysclk = twl6040_get_sysclk(twl6040);
codec->dapm.bias_level = level;
return 0;
......@@ -1371,14 +1368,8 @@ static int twl6040_hw_params(struct snd_pcm_substream *substream,
{
struct snd_soc_pcm_runtime *rtd = substream->private_data;
struct snd_soc_codec *codec = rtd->codec;
struct twl6040 *twl6040 = codec->control_data;
struct twl6040_data *priv = snd_soc_codec_get_drvdata(codec);
unsigned int sysclk;
int rate, ret;
/* nothing to do for high-perf pll, it supports only 48 kHz */
if (priv->pll == TWL6040_HPPLL_ID)
return 0;
int rate;
rate = params_rate(params);
switch (rate) {
......@@ -1386,26 +1377,33 @@ static int twl6040_hw_params(struct snd_pcm_substream *substream,
case 22500:
case 44100:
case 88200:
sysclk = 17640000;
/* These rates are not supported when HPPLL is in use */
if (unlikely(priv->pll == TWL6040_SYSCLK_SEL_HPPLL)) {
dev_err(codec->dev, "HPPLL does not support rate %d\n",
rate);
return -EINVAL;
}
/* Capture is not supported with 17.64MHz sysclk */
if (substream->stream == SNDRV_PCM_STREAM_CAPTURE) {
dev_err(codec->dev,
"capture mode is not supported at %dHz\n",
rate);
return -EINVAL;
}
priv->sysclk = 17640000;
break;
case 8000:
case 16000:
case 32000:
case 48000:
case 96000:
sysclk = 19200000;
priv->sysclk = 19200000;
break;
default:
dev_err(codec->dev, "unsupported rate %d\n", rate);
return -EINVAL;
}
ret = twl6040_set_pll(twl6040, TWL6040_LPPLL_ID, priv->clk_in, sysclk);
if (ret)
return ret;
priv->sysclk = twl6040_get_sysclk(twl6040);
return 0;
}
......@@ -1414,7 +1412,9 @@ static int twl6040_prepare(struct snd_pcm_substream *substream,
{
struct snd_soc_pcm_runtime *rtd = substream->private_data;
struct snd_soc_codec *codec = rtd->codec;
struct twl6040 *twl6040 = codec->control_data;
struct twl6040_data *priv = snd_soc_codec_get_drvdata(codec);
int ret;
if (!priv->sysclk) {
dev_err(codec->dev,
......@@ -1422,24 +1422,19 @@ static int twl6040_prepare(struct snd_pcm_substream *substream,
return -EINVAL;
}
/*
* capture is not supported at 17.64 MHz,
* it's reserved for headset low-power playback scenario
*/
if ((priv->sysclk == 17640000) &&
substream->stream == SNDRV_PCM_STREAM_CAPTURE) {
dev_err(codec->dev,
"capture mode is not supported at %dHz\n",
priv->sysclk);
return -EINVAL;
}
if ((priv->sysclk == 17640000) && priv->non_lp) {
dev_err(codec->dev,
"some enabled paths aren't supported at %dHz\n",
priv->sysclk);
return -EPERM;
}
ret = twl6040_set_pll(twl6040, priv->pll, priv->clk_in, priv->sysclk);
if (ret) {
dev_err(codec->dev, "Can not set PLL (%d)\n", ret);
return -EPERM;
}
return 0;
}
......@@ -1447,32 +1442,19 @@ static int twl6040_set_dai_sysclk(struct snd_soc_dai *codec_dai,
int clk_id, unsigned int freq, int dir)
{
struct snd_soc_codec *codec = codec_dai->codec;
struct twl6040 *twl6040 = codec->control_data;
struct twl6040_data *priv = snd_soc_codec_get_drvdata(codec);
int ret = 0;
switch (clk_id) {
case TWL6040_SYSCLK_SEL_LPPLL:
ret = twl6040_set_pll(twl6040, TWL6040_LPPLL_ID,
freq, priv->sysclk);
if (ret)
return ret;
break;
case TWL6040_SYSCLK_SEL_HPPLL:
ret = twl6040_set_pll(twl6040, TWL6040_HPPLL_ID,
freq, priv->sysclk);
if (ret)
return ret;
priv->pll = clk_id;
priv->clk_in = freq;
break;
default:
dev_err(codec->dev, "unknown clk_id %d\n", clk_id);
return -EINVAL;
}
priv->pll = twl6040_get_pll(twl6040);
priv->clk_in = freq;
priv->sysclk = twl6040_get_sysclk(twl6040);
return 0;
}
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册