IB/ehca: In case of lost interrupts, trigger EOI to reenable interrupts

During corner case testing, we noticed that some versions of ehca do
not properly transition to interrupt done in special load situations.
This can be resolved by periodically triggering EOI through H_EOI, if
EQEs are pending.
Signed-off-by: NStefan Roscher <stefan.roscher@de.ibm.com>
Acked-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

drivers/infiniband/hw/ehca/ehca_irq.c

@@ -531,7 +531,7 @@ void ehca_process_eq(struct ehca_shca *shca, int is_irq)
 {
 	struct ehca_eq *eq = &shca->eq;
 	struct ehca_eqe_cache_entry *eqe_cache = eq->eqe_cache;
-	u64 eqe_value;
+	u64 eqe_value, ret;
 	unsigned long flags;
 	int eqe_cnt, i;
 	int eq_empty = 0;
@@ -583,8 +583,13 @@ void ehca_process_eq(struct ehca_shca *shca, int is_irq)
 			ehca_dbg(&shca->ib_device,
 				 "No eqe found for irq event");
 		goto unlock_irq_spinlock;
-	} else if (!is_irq)
+	} else if (!is_irq) {
+		ret = hipz_h_eoi(eq->ist);
+		if (ret != H_SUCCESS)
+			ehca_err(&shca->ib_device,
+				 "bad return code EOI -rc = %ld\n", ret);
 		ehca_dbg(&shca->ib_device, "deadman found %x eqe", eqe_cnt);
+	}
 	if (unlikely(eqe_cnt == EHCA_EQE_CACHE_SIZE))
 		ehca_dbg(&shca->ib_device, "too many eqes for one irq event");
 	/* enable irq for new packets */

drivers/infiniband/hw/ehca/hcp_if.c

@@ -933,3 +933,13 @@ u64 hipz_h_error_data(const struct ipz_adapter_handle adapter_handle,
 				       r_cb,
 				       0, 0, 0, 0);
 }
+
+u64 hipz_h_eoi(int irq)
+{
+	unsigned long xirr;
+
+	iosync();
+	xirr = (0xffULL << 24) | irq;
+
+	return plpar_hcall_norets(H_EOI, xirr);
+}

drivers/infiniband/hw/ehca/hcp_if.h

@@ -260,5 +260,6 @@ u64 hipz_h_error_data(const struct ipz_adapter_handle adapter_handle,
 		      const u64 ressource_handle,
 		      void *rblock,
 		      unsigned long *byte_count);
+u64 hipz_h_eoi(int irq);
 
 #endif /* __HCP_IF_H__ */