usb: dwc2: gadget: report disconnection after reset

If usb bus is reset without a physical disconnection, all endpoints
will remain open. Call s3c_hsotg_disconnect() from reset handler to
report a disconnect to gadget framework. hsotg->connected is checked
in s3c_hsotg_disconnect() before processing disconnect.

In some cases, USBRst is seen before EnumDone and after it as well.
So move setting of hsotg->connected to set-address to avoid reporting
extra disconnection in this case.
Tested-by: NRobert Baldyga <r.baldyga@samsung.com>
Acked-by: NPaul Zimmerman <paulz@synopsys.com>
Signed-off-by: NMian Yousaf Kaukab <yousaf.kaukab@intel.com>
Signed-off-by: NFelipe Balbi <balbi@ti.com>

drivers/usb/dwc2/gadget.c

@@ -1103,6 +1103,7 @@ static void s3c_hsotg_process_control(struct dwc2_hsotg *hsotg,
 	if ((ctrl->bRequestType & USB_TYPE_MASK) == USB_TYPE_STANDARD) {
 		switch (ctrl->bRequest) {
 		case USB_REQ_SET_ADDRESS:
+			hsotg->connected = 1;
 			dcfg = readl(hsotg->regs + DCFG);
 			dcfg &= ~DCFG_DEVADDR_MASK;
 			dcfg |= (le16_to_cpu(ctrl->wValue) <<
@@ -2305,7 +2306,6 @@ static irqreturn_t s3c_hsotg_irq(int irq, void *pw)
 		writel(GINTSTS_ENUMDONE, hsotg->regs + GINTSTS);
 
 		s3c_hsotg_irq_enumdone(hsotg);
-		hsotg->connected = 1;
 	}
 
 	if (gintsts & (GINTSTS_OEPINT | GINTSTS_IEPINT)) {
@@ -2343,6 +2343,9 @@ static irqreturn_t s3c_hsotg_irq(int irq, void *pw)
 
 		writel(GINTSTS_USBRST, hsotg->regs + GINTSTS);
 
+		/* Report disconnection if it is not already done. */
+		s3c_hsotg_disconnect(hsotg);
+
 		if (usb_status & GOTGCTL_BSESVLD) {
 			if (time_after(jiffies, hsotg->last_rst +
 				       msecs_to_jiffies(200))) {