[POWERPC] 85xxCDS: Make sure restart resets the PCI bus.

The current 85xxCDS restart code fails to reset the PCI bus which can
lead to odd behavior after the restart. This patch uses the VIA Super
Southbridge to perform a PCI reset which will reset the entire system.
NOTE: Since the VIA chip is behind a PCI-to-PCI bridge which can be
disabled with a switch setting, it may not be possible to perform the
PCI bus reset. In this case, the code defaults to the previous restart
mechanism.
Signed-off-by: NRandy Vinson <rvinson@mvista.com>
Signed-off-by: NKumar Gala <galak@kernel.crashing.org>

arch/powerpc/platforms/85xx/mpc85xx_cds.c

@@ -69,6 +69,37 @@ static int mpc85xx_exclude_device(struct pci_controller *hose,
 		return PCIBIOS_SUCCESSFUL;
 }
 
+static void mpc85xx_cds_restart(char *cmd)
+{
+	struct pci_dev *dev;
+	u_char tmp;
+
+	if ((dev = pci_get_device(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C686,
+					NULL))) {
+
+		/* Use the VIA Super Southbridge to force a PCI reset */
+		pci_read_config_byte(dev, 0x47, &tmp);
+		pci_write_config_byte(dev, 0x47, tmp | 1);
+
+		/* Flush the outbound PCI write queues */
+		pci_read_config_byte(dev, 0x47, &tmp);
+
+		/*
+		 *  At this point, the harware reset should have triggered.
+		 *  However, if it doesn't work for some mysterious reason,
+		 *  just fall through to the default reset below.
+		 */
+
+		pci_dev_put(dev);
+	}
+
+	/*
+	 *  If we can't find the VIA chip (maybe the P2P bridge is disabled)
+	 *  or the VIA chip reset didn't work, just use the default reset.
+	 */
+	mpc85xx_restart(NULL);
+}
+
 static void __init mpc85xx_cds_pci_irq_fixup(struct pci_dev *dev)
 {
 	u_char c;
@@ -304,7 +335,11 @@ define_machine(mpc85xx_cds) {
 	.init_IRQ	= mpc85xx_cds_pic_init,
 	.show_cpuinfo	= mpc85xx_cds_show_cpuinfo,
 	.get_irq	= mpic_get_irq,
+#ifdef CONFIG_PCI
+	.restart	= mpc85xx_cds_restart,
+#else
 	.restart	= mpc85xx_restart,
+#endif
 	.calibrate_decr = generic_calibrate_decr,
 	.progress	= udbg_progress,
 	.pcibios_fixup_bus	= fsl_pcibios_fixup_bus,