提交 577eebea 编写于 作者: J Jeremy Fitzhardinge

xen: make -fstack-protector work under Xen

-fstack-protector uses a special per-cpu "stack canary" value.
gcc generates special code in each function to test the canary to make
sure that the function's stack hasn't been overrun.

On x86-64, this is simply an offset of %gs, which is the usual per-cpu
base segment register, so setting it up simply requires loading %gs's
base as normal.

On i386, the stack protector segment is %gs (rather than the usual kernel
percpu %fs segment register).  This requires setting up the full kernel
GDT and then loading %gs accordingly.  We also need to make sure %gs is
initialized when bringing up secondary cpus too.

To keep things consistent, we do the full GDT/segment register setup on
both architectures.

Because we need to avoid -fstack-protected code before setting up the GDT
and because there's no way to disable it on a per-function basis, several
files need to have stack-protector inhibited.

[ Impact: allow Xen booting with stack-protector enabled ]
Signed-off-by: NJeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
上级 e07cccf4
obj-y := init.o init_$(BITS).o fault.o ioremap.o extable.o pageattr.o mmap.o \
pat.o pgtable.o gup.o
# Make sure __phys_addr has no stackprotector
nostackp := $(call cc-option, -fno-stack-protector)
CFLAGS_ioremap.o := $(nostackp)
obj-$(CONFIG_SMP) += tlb.o
obj-$(CONFIG_X86_32) += pgtable_32.o iomap_32.o
......
......@@ -8,6 +8,7 @@ endif
# Make sure early boot has no stackprotector
nostackp := $(call cc-option, -fno-stack-protector)
CFLAGS_enlighten.o := $(nostackp)
CFLAGS_mmu.o := $(nostackp)
obj-y := enlighten.o setup.o multicalls.o mmu.o irq.o \
time.o xen-asm.o xen-asm_$(BITS).o \
......@@ -16,3 +17,4 @@ obj-y := enlighten.o setup.o multicalls.o mmu.o irq.o \
obj-$(CONFIG_SMP) += smp.o
obj-$(CONFIG_PARAVIRT_SPINLOCKS)+= spinlock.o
obj-$(CONFIG_XEN_DEBUG_FS) += debugfs.o
......@@ -51,6 +51,7 @@
#include <asm/pgtable.h>
#include <asm/tlbflush.h>
#include <asm/reboot.h>
#include <asm/stackprotector.h>
#include "xen-ops.h"
#include "mmu.h"
......@@ -330,18 +331,28 @@ static void xen_load_gdt(const struct desc_ptr *dtr)
unsigned long frames[pages];
int f;
/* A GDT can be up to 64k in size, which corresponds to 8192
8-byte entries, or 16 4k pages.. */
/*
* A GDT can be up to 64k in size, which corresponds to 8192
* 8-byte entries, or 16 4k pages..
*/
BUG_ON(size > 65536);
BUG_ON(va & ~PAGE_MASK);
for (f = 0; va < dtr->address + size; va += PAGE_SIZE, f++) {
int level;
pte_t *ptep = lookup_address(va, &level);
pte_t *ptep;
unsigned long pfn, mfn;
void *virt;
/*
* The GDT is per-cpu and is in the percpu data area.
* That can be virtually mapped, so we need to do a
* page-walk to get the underlying MFN for the
* hypercall. The page can also be in the kernel's
* linear range, so we need to RO that mapping too.
*/
ptep = lookup_address(va, &level);
BUG_ON(ptep == NULL);
pfn = pte_pfn(*ptep);
......@@ -358,6 +369,44 @@ static void xen_load_gdt(const struct desc_ptr *dtr)
BUG();
}
/*
* load_gdt for early boot, when the gdt is only mapped once
*/
static __init void xen_load_gdt_boot(const struct desc_ptr *dtr)
{
unsigned long va = dtr->address;
unsigned int size = dtr->size + 1;
unsigned pages = (size + PAGE_SIZE - 1) / PAGE_SIZE;
unsigned long frames[pages];
int f;
/*
* A GDT can be up to 64k in size, which corresponds to 8192
* 8-byte entries, or 16 4k pages..
*/
BUG_ON(size > 65536);
BUG_ON(va & ~PAGE_MASK);
for (f = 0; va < dtr->address + size; va += PAGE_SIZE, f++) {
pte_t pte;
unsigned long pfn, mfn;
pfn = virt_to_pfn(va);
mfn = pfn_to_mfn(pfn);
pte = pfn_pte(pfn, PAGE_KERNEL_RO);
if (HYPERVISOR_update_va_mapping((unsigned long)va, pte, 0))
BUG();
frames[f] = mfn;
}
if (HYPERVISOR_set_gdt(frames, size / sizeof(struct desc_struct)))
BUG();
}
static void load_TLS_descriptor(struct thread_struct *t,
unsigned int cpu, unsigned int i)
{
......@@ -581,6 +630,29 @@ static void xen_write_gdt_entry(struct desc_struct *dt, int entry,
preempt_enable();
}
/*
* Version of write_gdt_entry for use at early boot-time needed to
* update an entry as simply as possible.
*/
static __init void xen_write_gdt_entry_boot(struct desc_struct *dt, int entry,
const void *desc, int type)
{
switch (type) {
case DESC_LDT:
case DESC_TSS:
/* ignore */
break;
default: {
xmaddr_t maddr = virt_to_machine(&dt[entry]);
if (HYPERVISOR_update_descriptor(maddr.maddr, *(u64 *)desc))
dt[entry] = *(struct desc_struct *)desc;
}
}
}
static void xen_load_sp0(struct tss_struct *tss,
struct thread_struct *thread)
{
......@@ -965,6 +1037,23 @@ static const struct machine_ops __initdata xen_machine_ops = {
.emergency_restart = xen_emergency_restart,
};
/*
* Set up the GDT and segment registers for -fstack-protector. Until
* we do this, we have to be careful not to call any stack-protected
* function, which is most of the kernel.
*/
static void __init xen_setup_stackprotector(void)
{
pv_cpu_ops.write_gdt_entry = xen_write_gdt_entry_boot;
pv_cpu_ops.load_gdt = xen_load_gdt_boot;
setup_stack_canary_segment(0);
switch_to_new_gdt(0);
pv_cpu_ops.write_gdt_entry = xen_write_gdt_entry;
pv_cpu_ops.load_gdt = xen_load_gdt;
}
/* First C function to be called on Xen boot */
asmlinkage void __init xen_start_kernel(void)
{
......@@ -983,13 +1072,28 @@ asmlinkage void __init xen_start_kernel(void)
pv_apic_ops = xen_apic_ops;
pv_mmu_ops = xen_mmu_ops;
#ifdef CONFIG_X86_64
/*
* Setup percpu state. We only need to do this for 64-bit
* because 32-bit already has %fs set properly.
* Set up some pagetable state before starting to set any ptes.
*/
load_percpu_segment(0);
#endif
/* Prevent unwanted bits from being set in PTEs. */
__supported_pte_mask &= ~_PAGE_GLOBAL;
if (!xen_initial_domain())
__supported_pte_mask &= ~(_PAGE_PWT | _PAGE_PCD);
__supported_pte_mask |= _PAGE_IOMAP;
xen_setup_features();
/* Get mfn list */
if (!xen_feature(XENFEAT_auto_translated_physmap))
xen_build_dynamic_phys_to_machine();
/*
* Set up kernel GDT and segment registers, mainly so that
* -fstack-protector code can be executed.
*/
xen_setup_stackprotector();
xen_init_irq_ops();
xen_init_cpuid_mask();
......@@ -1001,8 +1105,6 @@ asmlinkage void __init xen_start_kernel(void)
set_xen_basic_apic_ops();
#endif
xen_setup_features();
if (xen_feature(XENFEAT_mmu_pt_update_preserve_ad)) {
pv_mmu_ops.ptep_modify_prot_start = xen_ptep_modify_prot_start;
pv_mmu_ops.ptep_modify_prot_commit = xen_ptep_modify_prot_commit;
......@@ -1019,17 +1121,8 @@ asmlinkage void __init xen_start_kernel(void)
xen_smp_init();
/* Get mfn list */
if (!xen_feature(XENFEAT_auto_translated_physmap))
xen_build_dynamic_phys_to_machine();
pgd = (pgd_t *)xen_start_info->pt_base;
/* Prevent unwanted bits from being set in PTEs. */
__supported_pte_mask &= ~_PAGE_GLOBAL;
if (!xen_initial_domain())
__supported_pte_mask &= ~(_PAGE_PWT | _PAGE_PCD);
#ifdef CONFIG_X86_64
/* Work out if we support NX */
check_efer();
......
......@@ -236,6 +236,7 @@ cpu_initialize_context(unsigned int cpu, struct task_struct *idle)
ctxt->user_regs.ss = __KERNEL_DS;
#ifdef CONFIG_X86_32
ctxt->user_regs.fs = __KERNEL_PERCPU;
ctxt->user_regs.gs = __KERNEL_STACK_CANARY;
#else
ctxt->gs_base_kernel = per_cpu_offset(cpu);
#endif
......
obj-y += grant-table.o features.o events.o manage.o
obj-y += xenbus/
nostackp := $(call cc-option, -fno-stack-protector)
CFLAGS_features.o := $(nostackp)
obj-$(CONFIG_HOTPLUG_CPU) += cpu_hotplug.o
obj-$(CONFIG_XEN_XENCOMM) += xencomm.o
obj-$(CONFIG_XEN_BALLOON) += balloon.o
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册