提交 564d06b1 编写于 作者: A Arnd Bergmann 提交者: Kukjin Kim

ARM: EXYNOS: Remove remaining dead code after non-DT support removal

This patch removes remaining small bits of unused code that was left
after removing non-DT support.
Signed-off-by: NArnd Bergmann <arnd@arndb.de>
Signed-off-by: NTomasz Figa <t.figa@samsung.com>
Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: NKukjin Kim <kgene.kim@samsung.com>
上级 87107d89
......@@ -115,23 +115,6 @@ config MACH_EXYNOS5_DT
Machine support for Samsung EXYNOS5 machine with device tree enabled.
Select this if a fdt blob is available for the EXYNOS5 SoC based board.
if ARCH_EXYNOS4
comment "Configuration for HSMMC 8-bit bus width"
config EXYNOS4_SDHCI_CH0_8BIT
bool "Channel 0 with 8-bit bus"
help
Support HSMMC Channel 0 8-bit bus.
If selected, Channel 1 is disabled.
config EXYNOS4_SDHCI_CH2_8BIT
bool "Channel 2 with 8-bit bus"
help
Support HSMMC Channel 2 8-bit bus.
If selected, Channel 3 is disabled.
endif
endmenu
endif
......@@ -60,8 +60,6 @@ static void exynos5_map_io(void);
static void exynos5440_map_io(void);
static int exynos_init(void);
unsigned long xxti_f = 0, xusbxti_f = 0;
static struct cpu_table cpu_ids[] __initdata = {
{
.idcode = EXYNOS4210_CPU_ID,
......@@ -322,7 +320,7 @@ void __init exynos_init_late(void)
exynos_pm_late_initcall();
}
int __init exynos_fdt_map_chipid(unsigned long node, const char *uname,
static int __init exynos_fdt_map_chipid(unsigned long node, const char *uname,
int depth, void *data)
{
struct map_desc iodesc;
......
......@@ -34,12 +34,7 @@ static inline void s3c_pm_debug_init_uart(void)
static inline void s3c_pm_arch_prepare_irqs(void)
{
u32 eintmask = s3c_irqwake_eintmask;
if (of_have_populated_dt())
eintmask = exynos_get_eint_wake_mask();
__raw_writel(eintmask, S5P_EINT_WAKEUP_MASK);
__raw_writel(exynos_get_eint_wake_mask(), S5P_EINT_WAKEUP_MASK);
__raw_writel(s3c_irqwake_intmask & ~(1 << 31), S5P_WAKEUP_MASK);
}
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册