mmc: sh_mmcif: Add support for eMMC Dual Data Rate

Some MMCIF implementations support the Dual Data Rate. With this patch,
platforms can set the MMC_CAP_UHS_DDR50 capability flag in MMCIF platform
data. This will let the MMC core to actually use the DDR mode.
Signed-off-by: NTeppei Kamijou <teppei.kamijou.yb@renesas.com>
Signed-off-by: NShinya Kuribayashi <shinya.kuribayashi.px@renesas.com>
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@gmx.de>
Signed-off-by: NChris Ball <cjb@laptop.org>

drivers/mmc/host/sh_mmcif.c

@@ -88,6 +88,7 @@
 #define CMD_SET_TBIT		(1 << 7) /* 1: tran mission bit "Low" */
 #define CMD_SET_OPDM		(1 << 6) /* 1: open/drain */
 #define CMD_SET_CCSH		(1 << 5)
+#define CMD_SET_DARS		(1 << 2) /* Dual Data Rate */
 #define CMD_SET_DATW_1		((0 << 1) | (0 << 0)) /* 1bit */
 #define CMD_SET_DATW_4		((0 << 1) | (1 << 0)) /* 4bit */
 #define CMD_SET_DATW_8		((1 << 1) | (0 << 0)) /* 8bit */
@@ -216,6 +217,7 @@ struct sh_mmcif_host {
 	struct clk *hclk;
 	unsigned int clk;
 	int bus_width;
+	unsigned char timing;
 	bool sd_error;
 	bool dying;
 	long timeout;
@@ -781,6 +783,17 @@ static u32 sh_mmcif_set_cmd(struct sh_mmcif_host *host,
 			dev_err(&host->pd->dev, "Unsupported bus width.\n");
 			break;
 		}
+		switch (host->timing) {
+		case MMC_TIMING_UHS_DDR50:
+			/*
+			 * MMC core will only set this timing, if the host
+			 * advertises the MMC_CAP_UHS_DDR50 capability. MMCIF
+			 * implementations with this capability, e.g. sh73a0,
+			 * will have to set it in their platform data.
+			 */
+			tmp |= CMD_SET_DARS;
+			break;
+		}
 	}
 	/* DWEN */
 	if (opc == MMC_WRITE_BLOCK || opc == MMC_WRITE_MULTIPLE_BLOCK)
@@ -1002,6 +1015,7 @@ static void sh_mmcif_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
 		sh_mmcif_clock_control(host, ios->clock);
 	}
 
+	host->timing = ios->timing;
 	host->bus_width = ios->bus_width;
 	host->state = STATE_IDLE;
 }