提交 5459148b 编写于 作者: B Ben Dooks 提交者: Kukjin Kim

ARM: SAMSUNG: Add s3c_gpio_cfgall_range() function

Add a function to configure a range of GPIOs function and
pull in one go, mainly for the SDHCI and framebuffer helpers
which tend to do this.
Signed-off-by: NBen Dooks <ben-linux@fluff.org>
[kgene.kim@samsung.com: Fix small comments]
Signed-off-by: NKukjin Kim <kgene.kim@samsung.com>
上级 ce5d3ac1
......@@ -56,6 +56,22 @@ int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr,
}
EXPORT_SYMBOL_GPL(s3c_gpio_cfgpin_range);
int s3c_gpio_cfgall_range(unsigned int start, unsigned int nr,
unsigned int cfg, s3c_gpio_pull_t pull)
{
int ret;
for (; nr > 0; nr--, start++) {
s3c_gpio_setpull(start, pull);
ret = s3c_gpio_cfgpin(start, cfg);
if (ret != 0)
return ret;
}
return 0;
}
EXPORT_SYMBOL_GPL(s3c_gpio_cfgall_range);
unsigned s3c_gpio_getcfg(unsigned int pin)
{
struct s3c_gpio_chip *chip = s3c_gpiolib_getchip(pin);
......
......@@ -153,6 +153,25 @@ extern int s3c_gpio_setpull(unsigned int pin, s3c_gpio_pull_t pull);
*/
extern s3c_gpio_pull_t s3c_gpio_getpull(unsigned int pin);
/* configure `all` aspects of an gpio */
/**
* s3c_gpio_cfgall_range() - configure range of gpio functtion and pull.
* @start: The gpio number to start at.
* @nr: The number of gpio to configure from @start.
* @cfg: The configuration to use
* @pull: The pull setting to use.
*
* Run s3c_gpio_cfgpin() and s3c_gpio_setpull() over the gpio range starting
* @gpio and running for @size.
*
* @sa s3c_gpio_cfgpin
* @sa s3c_gpio_setpull
* @sa s3c_gpio_cfgpin_range
*/
extern int s3c_gpio_cfgall_range(unsigned int start, unsigned int nr,
unsigned int cfg, s3c_gpio_pull_t pull);
/* Define values for the drvstr available for each gpio pin.
*
* These values control the value of the output signal driver strength,
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册