提交 5253ffb8 编写于 作者: K Karl Beldan 提交者: Johannes Berg

mac80211: always pick a basic rate to tx RTS/CTS for pre-HT rates

When the 1st rate control entry is a pre-HT rate we want to set
rts_cts_rate_idx "as the fastest basic rate that is not faster than the
data rate"(code comments).
But in case some bss allowed rate indexes are lower than the lowest bss
basic rate, if the rate control selects a rate among the formers for its
1st rate control entry, rts_cts_rate_idx remains 0 and is not a basic
rate index.
This commit sets rts_cts_rate_idx to the lowest bss basic rate index in
this situation.

Note that the code assumes that lowest indexes == lowest bitrates.
Signed-off-by: NKarl Beldan <karl.beldan@rivierawaves.com>
Signed-off-by: NJohannes Berg <johannes.berg@intel.com>
上级 2419ea14
......@@ -712,19 +712,22 @@ ieee80211_tx_h_rate_ctrl(struct ieee80211_tx_data *tx)
}
/*
* set up the RTS/CTS rate as the fastest basic rate
* that is not faster than the data rate
* Set up the RTS/CTS rate as the fastest basic rate
* that is not faster than the data rate unless there
* is no basic rate slower than the data rate, in which
* case we pick the slowest basic rate
*
* XXX: Should this check all retry rates?
*/
if (!(info->control.rates[0].flags & IEEE80211_TX_RC_MCS)) {
s8 baserate = 0;
u32 basic_rates = tx->sdata->vif.bss_conf.basic_rates;
s8 baserate = basic_rates ? ffs(basic_rates - 1) : 0;
rate = &sband->bitrates[info->control.rates[0].idx];
for (i = 0; i < sband->n_bitrates; i++) {
/* must be a basic rate */
if (!(tx->sdata->vif.bss_conf.basic_rates & BIT(i)))
if (!(basic_rates & BIT(i)))
continue;
/* must not be faster than the data rate */
if (sband->bitrates[i].bitrate > rate->bitrate)
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册