提交 4c14d78e 编写于 作者: M Mark Brown

ASoC: Use delayed work for debounce of GPIO based jacks

Rather than block the workqueue by sleeping to do the debounce use delayed
work to implement the debounce time. This should also means that we extend
the debounce time on each new bounce, potentially allowing shorter debounce
times for clean insertions.
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Acked-by: NJarkko Nikula <jhnikula@gmail.com>
Acked-by: NLiam Girdwood <lrg@slimlogic.co.uk>
上级 de535a5b
......@@ -385,7 +385,7 @@ struct snd_soc_jack_gpio {
int invert;
int debounce_time;
struct snd_soc_jack *jack;
struct work_struct work;
struct delayed_work work;
int (*jack_status_check)(void);
};
......
......@@ -188,9 +188,6 @@ static void snd_soc_jack_gpio_detect(struct snd_soc_jack_gpio *gpio)
int enable;
int report;
if (gpio->debounce_time > 0)
mdelay(gpio->debounce_time);
enable = gpio_get_value(gpio->gpio);
if (gpio->invert)
enable = !enable;
......@@ -211,7 +208,8 @@ static irqreturn_t gpio_handler(int irq, void *data)
{
struct snd_soc_jack_gpio *gpio = data;
schedule_work(&gpio->work);
schedule_delayed_work(&gpio->work,
msecs_to_jiffies(gpio->debounce_time));
return IRQ_HANDLED;
}
......@@ -221,7 +219,7 @@ static void gpio_work(struct work_struct *work)
{
struct snd_soc_jack_gpio *gpio;
gpio = container_of(work, struct snd_soc_jack_gpio, work);
gpio = container_of(work, struct snd_soc_jack_gpio, work.work);
snd_soc_jack_gpio_detect(gpio);
}
......@@ -262,7 +260,7 @@ int snd_soc_jack_add_gpios(struct snd_soc_jack *jack, int count,
if (ret)
goto err;
INIT_WORK(&gpios[i].work, gpio_work);
INIT_DELAYED_WORK(&gpios[i].work, gpio_work);
gpios[i].jack = jack;
ret = request_irq(gpio_to_irq(gpios[i].gpio),
......@@ -312,6 +310,7 @@ void snd_soc_jack_free_gpios(struct snd_soc_jack *jack, int count,
gpio_unexport(gpios[i].gpio);
#endif
free_irq(gpio_to_irq(gpios[i].gpio), &gpios[i]);
cancel_delayed_work_sync(&gpios[i].work);
gpio_free(gpios[i].gpio);
gpios[i].jack = NULL;
}
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册