net: ethernet: nixge: Add support for National Instruments XGE netdev

Add support for the National Instruments XGE 1/10G network device.

It uses the EEPROM on the board via NVMEM.
Signed-off-by: NMoritz Fischer <mdf@kernel.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/Kconfig

@@ -129,6 +129,7 @@ config FEALNX
 
 source "drivers/net/ethernet/natsemi/Kconfig"
 source "drivers/net/ethernet/netronome/Kconfig"
+source "drivers/net/ethernet/ni/Kconfig"
 source "drivers/net/ethernet/8390/Kconfig"
 
 config NET_NETX

drivers/net/ethernet/Makefile

@@ -61,6 +61,7 @@ obj-$(CONFIG_NET_VENDOR_MYRI) += myricom/
 obj-$(CONFIG_FEALNX) += fealnx.o
 obj-$(CONFIG_NET_VENDOR_NATSEMI) += natsemi/
 obj-$(CONFIG_NET_VENDOR_NETRONOME) += netronome/
+obj-$(CONFIG_NET_VENDOR_NI) += ni/
 obj-$(CONFIG_NET_NETX) += netx-eth.o
 obj-$(CONFIG_NET_VENDOR_NUVOTON) += nuvoton/
 obj-$(CONFIG_NET_VENDOR_NVIDIA) += nvidia/

drivers/net/ethernet/ni/Kconfig

+#
+# National Instuments network device configuration
+#
+
+config NET_VENDOR_NI
+	bool "National Instruments Devices"
+	default y
+	help
+	  If you have a network (Ethernet) device belonging to this class, say Y.
+
+	  Note that the answer to this question doesn't directly affect the
+	  kernel: saying N will just cause the configurator to skip all
+	  the questions about National Instrument devices.
+	  If you say Y, you will be asked for your specific device in the
+	  following questions.
+
+if NET_VENDOR_NI
+
+config NI_XGE_MANAGEMENT_ENET
+	tristate "National Instruments XGE management enet support"
+	depends on ARCH_ZYNQ
+	select PHYLIB
+	help
+	  Simple LAN device for debug or management purposes. Can
+	  support either 10G or 1G PHYs via SFP+ ports.
+
+endif

drivers/net/ethernet/ni/Makefile

+obj-$(CONFIG_NI_XGE_MANAGEMENT_ENET) += nixge.o