arm: convert pcm037 platform to use smsc911x

Updated to also specify SMSC911X_FORCE_INTERNAL_PHY, as the external phy
detection hardware strap is incorrectly pulled high on this platform.
Signed-off-by: NSteve Glendinning <steve.glendinning@smsc.com>
Acked-by: NSascha Hauer <s.hauer@pengutronix.de>
Tested-by: NSascha Hauer <s.hauer@pengutronix.de>

arch/arm/mach-mx3/pcm037.c

@@ -24,7 +24,7 @@
 #include <linux/mtd/plat-ram.h>
 #include <linux/memory.h>
 #include <linux/gpio.h>
-#include <linux/smc911x.h>
+#include <linux/smsc911x.h>
 #include <linux/interrupt.h>
 #include <linux/i2c.h>
 #include <linux/i2c/at24.h>
@@ -70,7 +70,7 @@ static struct imxuart_platform_data uart_pdata = {
 	.flags = IMXUART_HAVE_RTSCTS,
 };
 
-static struct resource smc911x_resources[] = {
+static struct resource smsc911x_resources[] = {
 	[0] = {
 		.start		= CS1_BASE_ADDR + 0x300,
 		.end		= CS1_BASE_ADDR + 0x300 + SZ_64K - 1,
@@ -79,22 +79,25 @@ static struct resource smc911x_resources[] = {
 	[1] = {
 		.start		= IOMUX_TO_IRQ(MX31_PIN_GPIO3_1),
 		.end		= IOMUX_TO_IRQ(MX31_PIN_GPIO3_1),
-		.flags		= IORESOURCE_IRQ,
+		.flags		= IORESOURCE_IRQ | IORESOURCE_IRQ_LOWLEVEL,
 	},
 };
 
-static struct smc911x_platdata smc911x_info = {
-	.flags		= SMC911X_USE_32BIT,
-	.irq_flags	= IRQF_SHARED | IRQF_TRIGGER_LOW,
+static struct smsc911x_platform_config smsc911x_info = {
+	.flags		= SMSC911X_USE_32BIT | SMSC911X_FORCE_INTERNAL_PHY |
+			  SMSC911X_SAVE_MAC_ADDRESS,
+	.irq_polarity	= SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
+	.irq_type	= SMSC911X_IRQ_TYPE_OPEN_DRAIN,
+	.phy_interface	= PHY_INTERFACE_MODE_MII,
 };
 
 static struct platform_device pcm037_eth = {
-	.name		= "smc911x",
+	.name		= "smsc911x",
 	.id		= -1,
-	.num_resources	= ARRAY_SIZE(smc911x_resources),
-	.resource	= smc911x_resources,
+	.num_resources	= ARRAY_SIZE(smsc911x_resources),
+	.resource	= smsc911x_resources,
 	.dev		= {
-		.platform_data = &smc911x_info,
+		.platform_data = &smsc911x_info,
 	},
 };