x86, acpi/irq: pci device dev->irq is an isa irq not a gsi

Strictly speaking on x86 (where acpi is used) dev->irq must be
a dual i8259 irq input aka an isa irq.  Therefore we should translate
that isa irq into a gsi before passing it to a function that
takes a gsi.
Signed-off-by: NEric W. Biederman <ebiederm@xmission.com>
LKML-Reference: <1269936436-7039-3-git-send-email-ebiederm@xmission.com>
Signed-off-by: NH. Peter Anvin <hpa@zytor.com>

drivers/acpi/pci_irq.c

@@ -401,11 +401,13 @@ int acpi_pci_irq_enable(struct pci_dev *dev)
 	 * driver reported one, then use it. Exit in any case.
 	 */
 	if (gsi < 0) {
+		u32 dev_gsi;
 		dev_warn(&dev->dev, "PCI INT %c: no GSI", pin_name(pin));
 		/* Interrupt Line values above 0xF are forbidden */
-		if (dev->irq > 0 && (dev->irq <= 0xF)) {
-			printk(" - using IRQ %d\n", dev->irq);
-			acpi_register_gsi(&dev->dev, dev->irq,
+		if (dev->irq > 0 && (dev->irq <= 0xF) &&
+		    (acpi_isa_irq_to_gsi(dev->irq, &dev_gsi) == 0)) {
+			printk(" - using ISA IRQ %d\n", dev->irq);
+			acpi_register_gsi(&dev->dev, dev_gsi,
 					  ACPI_LEVEL_SENSITIVE,
 					  ACPI_ACTIVE_LOW);
 			return 0;