net: fec: Support phys probed from devicetree and fixed-link

This adds support for specifying the phy to be used with the fec in the
devicetree using the standard phy-handle property and also supports
fixed-link.
Signed-off-by: NSascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: NUwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Documentation/devicetree/bindings/net/fsl-fec.txt

@@ -12,7 +12,14 @@ Optional properties:
   only if property "phy-reset-gpios" is available.  Missing the property
   will have the duration be 1 millisecond.  Numbers greater than 1000 are
   invalid and 1 millisecond will be used instead.
-- phy-supply: regulator that powers the Ethernet PHY.
+- phy-supply : regulator that powers the Ethernet PHY.
+- phy-handle : phandle to the PHY device connected to this device.
+- fixed-link : Assume a fixed link. See fixed-link.txt in the same directory.
+  Use instead of phy-handle.
+
+Optional subnodes:
+- mdio : specifies the mdio bus in the FEC, used as a container for phy nodes
+  according to phy.txt in the same directory
 
 Example:
 
@@ -25,3 +32,23 @@ ethernet@83fec000 {
 	local-mac-address = [00 04 9F 01 1B B9];
 	phy-supply = <&reg_fec_supply>;
 };
+
+Example with phy specified:
+
+ethernet@83fec000 {
+	compatible = "fsl,imx51-fec", "fsl,imx27-fec";
+	reg = <0x83fec000 0x4000>;
+	interrupts = <87>;
+	phy-mode = "mii";
+	phy-reset-gpios = <&gpio2 14 0>; /* GPIO2_14 */
+	local-mac-address = [00 04 9F 01 1B B9];
+	phy-supply = <&reg_fec_supply>;
+	phy-handle = <&ethphy>;
+	mdio {
+		ethphy: ethernet-phy@6 {
+			compatible = "ethernet-phy-ieee802.3-c22";
+			reg = <6>;
+			max-speed = <100>;
+		};
+	};
+};

drivers/net/ethernet/freescale/fec.h

@@ -310,6 +310,7 @@ struct fec_enet_private {
 	int	mii_timeout;
 	uint	phy_speed;
 	phy_interface_t	phy_interface;
+	struct device_node *phy_node;
 	int	link;
 	int	full_duplex;
 	int	speed;

drivers/net/ethernet/freescale/fec_main.c

@@ -52,6 +52,7 @@
 #include <linux/of.h>
 #include <linux/of_device.h>
 #include <linux/of_gpio.h>
+#include <linux/of_mdio.h>
 #include <linux/of_net.h>
 #include <linux/regulator/consumer.h>
 #include <linux/if_vlan.h>
@@ -1648,29 +1649,37 @@ static int fec_enet_mii_probe(struct net_device *ndev)
 
 	fep->phy_dev = NULL;
 
-	/* check for attached phy */
-	for (phy_id = 0; (phy_id < PHY_MAX_ADDR); phy_id++) {
-		if ((fep->mii_bus->phy_mask & (1 << phy_id)))
-			continue;
-		if (fep->mii_bus->phy_map[phy_id] == NULL)
-			continue;
-		if (fep->mii_bus->phy_map[phy_id]->phy_id == 0)
-			continue;
-		if (dev_id--)
-			continue;
-		strncpy(mdio_bus_id, fep->mii_bus->id, MII_BUS_ID_SIZE);
-		break;
-	}
+	if (fep->phy_node) {
+		phy_dev = of_phy_connect(ndev, fep->phy_node,
+					 &fec_enet_adjust_link, 0,
+					 fep->phy_interface);
+	} else {
+		/* check for attached phy */
+		for (phy_id = 0; (phy_id < PHY_MAX_ADDR); phy_id++) {
+			if ((fep->mii_bus->phy_mask & (1 << phy_id)))
+				continue;
+			if (fep->mii_bus->phy_map[phy_id] == NULL)
+				continue;
+			if (fep->mii_bus->phy_map[phy_id]->phy_id == 0)
+				continue;
+			if (dev_id--)
+				continue;
+			strncpy(mdio_bus_id, fep->mii_bus->id, MII_BUS_ID_SIZE);
+			break;
+		}
 
-	if (phy_id >= PHY_MAX_ADDR) {
-		netdev_info(ndev, "no PHY, assuming direct connection to switch\n");
-		strncpy(mdio_bus_id, "fixed-0", MII_BUS_ID_SIZE);
-		phy_id = 0;
+		if (phy_id >= PHY_MAX_ADDR) {
+			netdev_info(ndev, "no PHY, assuming direct connection to switch\n");
+			strncpy(mdio_bus_id, "fixed-0", MII_BUS_ID_SIZE);
+			phy_id = 0;
+		}
+
+		snprintf(phy_name, sizeof(phy_name),
+			 PHY_ID_FMT, mdio_bus_id, phy_id);
+		phy_dev = phy_connect(ndev, phy_name, &fec_enet_adjust_link,
+				      fep->phy_interface);
 	}
 
-	snprintf(phy_name, sizeof(phy_name), PHY_ID_FMT, mdio_bus_id, phy_id);
-	phy_dev = phy_connect(ndev, phy_name, &fec_enet_adjust_link,
-			      fep->phy_interface);
 	if (IS_ERR(phy_dev)) {
 		netdev_err(ndev, "could not attach to PHY\n");
 		return PTR_ERR(phy_dev);
@@ -1707,6 +1716,7 @@ static int fec_enet_mii_init(struct platform_device *pdev)
 	struct fec_enet_private *fep = netdev_priv(ndev);
 	const struct platform_device_id *id_entry =
 				platform_get_device_id(fep->pdev);
+	struct device_node *node;
 	int err = -ENXIO, i;
 
 	/*
@@ -1774,7 +1784,15 @@ static int fec_enet_mii_init(struct platform_device *pdev)
 	for (i = 0; i < PHY_MAX_ADDR; i++)
 		fep->mii_bus->irq[i] = PHY_POLL;
 
-	if (mdiobus_register(fep->mii_bus))
+	node = of_get_child_by_name(pdev->dev.of_node, "mdio");
+	if (node) {
+		err = of_mdiobus_register(fep->mii_bus, node);
+		of_node_put(node);
+	} else {
+		err = mdiobus_register(fep->mii_bus);
+	}
+
+	if (err)
 		goto err_out_free_mdio_irq;
 
 	mii_cnt++;
@@ -2527,6 +2545,7 @@ fec_probe(struct platform_device *pdev)
 	struct resource *r;
 	const struct of_device_id *of_id;
 	static int dev_id;
+	struct device_node *np = pdev->dev.of_node, *phy_node;
 
 	of_id = of_match_device(fec_dt_ids, &pdev->dev);
 	if (of_id)
@@ -2566,6 +2585,18 @@ fec_probe(struct platform_device *pdev)
 
 	platform_set_drvdata(pdev, ndev);
 
+	phy_node = of_parse_phandle(np, "phy-handle", 0);
+	if (!phy_node && of_phy_is_fixed_link(np)) {
+		ret = of_phy_register_fixed_link(np);
+		if (ret < 0) {
+			dev_err(&pdev->dev,
+				"broken fixed-link specification\n");
+			goto failed_phy;
+		}
+		phy_node = of_node_get(np);
+	}
+	fep->phy_node = phy_node;
+
 	ret = of_get_phy_mode(pdev->dev.of_node);
 	if (ret < 0) {
 		pdata = dev_get_platdata(&pdev->dev);
@@ -2670,6 +2701,8 @@ fec_probe(struct platform_device *pdev)
 failed_regulator:
 	fec_enet_clk_enable(ndev, false);
 failed_clk:
+failed_phy:
+	of_node_put(phy_node);
 failed_ioremap:
 	free_netdev(ndev);
 
@@ -2691,6 +2724,7 @@ fec_drv_remove(struct platform_device *pdev)
 	if (fep->ptp_clock)
 		ptp_clock_unregister(fep->ptp_clock);
 	fec_enet_clk_enable(ndev, false);
+	of_node_put(fep->phy_node);
 	free_netdev(ndev);
 
 	return 0;