usb: gadget: serial: fix re-ordering of tx data

When a single thread is sending out data over the gadget serial port,
gs_start_tx() will be called both from the sender context and from the
write completion. Since the port lock is released before the packet is
queued, the order in which the URBs are submitted is not guaranteed.
E.g.

  sending thread                      completion (interrupt)

  gs_write()
    LOCK
                                      gs_write_complete()
                                        LOCK (wait)
    gs_start_tx()
      req1 = list_entry(pool->next)
      UNLOCK
                                        LOCK (acquired)
                                        gs_start_tx()
                                          req2 = list_entry(pool->next)
                                          UNLOCK
                                          usb_ep_queue(req2)
      usb_ep_queue(req1)

I.e., req2 is submitted before req1 but it contains the data that
comes after req1.

To reproduce, use SMP with sending thread and completion pinned to
different CPUs, or use PREEMPT_RT, and add the following delay just
before the call to usb_ep_queue():

		if (port->write_started > 0 && !list_empty(pool))
			udelay(1000);

To work around this problem, make sure that only one thread is running
through the gs_start_tx() loop with an extra flag write_busy. Since
gs_start_tx() is always called with the port lock held, no further
synchronisation is needed. The original caller will continue through
the loop when the request was successfully submitted.
Signed-off-by: NPhilip Oberstaller <Philip.Oberstaller@septentrio.com>
Signed-off-by: NArnout Vandecappelle (Essensium/Mind) <arnout@mind.be>
Signed-off-by: NFelipe Balbi <balbi@ti.com>

drivers/usb/gadget/function/u_serial.c

@@ -113,6 +113,7 @@ struct gs_port {
 	int write_allocated;
 	struct gs_buf		port_write_buf;
 	wait_queue_head_t	drain_wait;	/* wait while writes drain */
+	bool                    write_busy;
 
 	/* REVISIT this state ... */
 	struct usb_cdc_line_coding port_line_coding;	/* 8-N-1 etc */
@@ -363,7 +364,7 @@ __acquires(&port->port_lock)
 	int			status = 0;
 	bool			do_tty_wake = false;
 
-	while (!list_empty(pool)) {
+	while (!port->write_busy && !list_empty(pool)) {
 		struct usb_request	*req;
 		int			len;
 
@@ -393,9 +394,11 @@ __acquires(&port->port_lock)
 		 * NOTE that we may keep sending data for a while after
 		 * the TTY closed (dev->ioport->port_tty is NULL).
 		 */
+		port->write_busy = true;
 		spin_unlock(&port->port_lock);
 		status = usb_ep_queue(in, req, GFP_ATOMIC);
 		spin_lock(&port->port_lock);
+		port->write_busy = false;
 
 		if (status) {
 			pr_debug("%s: %s %s err %d\n",