mac80211: Add set_cqm_rssi_range_config

Support .set_cqm_rssi_range_config if the beacons are available for
processing in mac80211.  There's no reason that this couldn't be
offloaded by mac80211-based drivers but there's no driver method for
that added in this patch.
Signed-off-by: NAndrew Zaborowski <andrew.zaborowski@intel.com>
Signed-off-by: NJohannes Berg <johannes.berg@intel.com>

include/net/mac80211.h

@@ -501,6 +501,10 @@ struct ieee80211_mu_group_data {
  *	implies disabled. As with the cfg80211 callback, a change here should
  *	cause an event to be sent indicating where the current value is in
  *	relation to the newly configured threshold.
+ * @cqm_rssi_low: Connection quality monitor RSSI lower threshold, a zero value
+ *	implies disabled.  This is an alternative mechanism to the single
+ *	threshold event and can't be enabled simultaneously with it.
+ * @cqm_rssi_high: Connection quality monitor RSSI upper threshold.
  * @cqm_rssi_hyst: Connection quality monitor RSSI hysteresis
  * @arp_addr_list: List of IPv4 addresses for hardware ARP filtering. The
  *	may filter ARP queries targeted for other addresses than listed here.
@@ -553,6 +557,8 @@ struct ieee80211_bss_conf {
 	u16 ht_operation_mode;
 	s32 cqm_rssi_thold;
 	u32 cqm_rssi_hyst;
+	s32 cqm_rssi_low;
+	s32 cqm_rssi_high;
 	struct cfg80211_chan_def chandef;
 	struct ieee80211_mu_group_data mu_group;
 	__be32 arp_addr_list[IEEE80211_BSS_ARP_ADDR_LIST_LEN];

net/mac80211/cfg.c

@@ -2630,6 +2630,33 @@ static int ieee80211_set_cqm_rssi_config(struct wiphy *wiphy,
 
 	bss_conf->cqm_rssi_thold = rssi_thold;
 	bss_conf->cqm_rssi_hyst = rssi_hyst;
+	bss_conf->cqm_rssi_low = 0;
+	bss_conf->cqm_rssi_high = 0;
+	sdata->u.mgd.last_cqm_event_signal = 0;
+
+	/* tell the driver upon association, unless already associated */
+	if (sdata->u.mgd.associated &&
+	    sdata->vif.driver_flags & IEEE80211_VIF_SUPPORTS_CQM_RSSI)
+		ieee80211_bss_info_change_notify(sdata, BSS_CHANGED_CQM);
+
+	return 0;
+}
+
+static int ieee80211_set_cqm_rssi_range_config(struct wiphy *wiphy,
+					       struct net_device *dev,
+					       s32 rssi_low, s32 rssi_high)
+{
+	struct ieee80211_sub_if_data *sdata = IEEE80211_DEV_TO_SUB_IF(dev);
+	struct ieee80211_vif *vif = &sdata->vif;
+	struct ieee80211_bss_conf *bss_conf = &vif->bss_conf;
+
+	if (sdata->vif.driver_flags & IEEE80211_VIF_BEACON_FILTER)
+		return -EOPNOTSUPP;
+
+	bss_conf->cqm_rssi_low = rssi_low;
+	bss_conf->cqm_rssi_high = rssi_high;
+	bss_conf->cqm_rssi_thold = 0;
+	bss_conf->cqm_rssi_hyst = 0;
 	sdata->u.mgd.last_cqm_event_signal = 0;
 
 	/* tell the driver upon association, unless already associated */
@@ -3639,6 +3666,7 @@ const struct cfg80211_ops mac80211_config_ops = {
 	.mgmt_tx = ieee80211_mgmt_tx,
 	.mgmt_tx_cancel_wait = ieee80211_mgmt_tx_cancel_wait,
 	.set_cqm_rssi_config = ieee80211_set_cqm_rssi_config,
+	.set_cqm_rssi_range_config = ieee80211_set_cqm_rssi_range_config,
 	.mgmt_frame_register = ieee80211_mgmt_frame_register,
 	.set_antenna = ieee80211_set_antenna,
 	.get_antenna = ieee80211_get_antenna,

net/mac80211/mlme.c

@@ -3430,6 +3430,30 @@ static void ieee80211_rx_mgmt_beacon(struct ieee80211_sub_if_data *sdata,
 		}
 	}
 
+	if (bss_conf->cqm_rssi_low &&
+	    ifmgd->count_beacon_signal >= IEEE80211_SIGNAL_AVE_MIN_COUNT) {
+		int sig = -ewma_beacon_signal_read(&ifmgd->ave_beacon_signal);
+		int last_event = ifmgd->last_cqm_event_signal;
+		int low = bss_conf->cqm_rssi_low;
+		int high = bss_conf->cqm_rssi_high;
+
+		if (sig < low &&
+		    (last_event == 0 || last_event >= low)) {
+			ifmgd->last_cqm_event_signal = sig;
+			ieee80211_cqm_rssi_notify(
+				&sdata->vif,
+				NL80211_CQM_RSSI_THRESHOLD_EVENT_LOW,
+				sig, GFP_KERNEL);
+		} else if (sig > high &&
+			   (last_event == 0 || last_event <= high)) {
+			ifmgd->last_cqm_event_signal = sig;
+			ieee80211_cqm_rssi_notify(
+				&sdata->vif,
+				NL80211_CQM_RSSI_THRESHOLD_EVENT_HIGH,
+				sig, GFP_KERNEL);
+		}
+	}
+
 	if (ifmgd->flags & IEEE80211_STA_CONNECTION_POLL) {
 		mlme_dbg_ratelimited(sdata,
 				     "cancelling AP probe due to a received beacon\n");