Merge tag 'v4.2-rockchip-dts1' of...

Merge tag 'v4.2-rockchip-dts1' of git://git.kernel.org/pub/scm/linux/kernel/git/mmind/linux-rockchip into next/dt

Merge "ARM: rockchip: dts changes for 4.2" from Heiko Stuebner:

Some misc improvements defining additional supply regulators, enabling
the Cortex-A12 HW PMU on the rk3288 and the tsadc on some more rk3288
boards, as well as some usb properties and marking the radxarock pmic
as system-power-controller.

* tag 'v4.2-rockchip-dts1' of git://git.kernel.org/pub/scm/linux/kernel/git/mmind/linux-rockchip:
  ARM: dts: rockchip: add system-power-controller to act8846 on radxarock
  ARM: dts: rockchip: add properties for dwc2 usb otg controller
  ARM: dts: rockchip: enable tsadc on rk3288 boards
  ARM: dts: rockchip: add act8846 supplies on rk3288-firefly
  ARM: dts: rockchip: Specify VMMC and VQMMC on rk3288-evb
  ARM: dts: rockchip: Enable Cortex-A12 HW PMU events on rk3288

arch/arm/boot/dts/rk3188-radxarock.dts

@@ -152,6 +152,7 @@
 		compatible = "active-semi,act8846";
 		reg = <0x5a>;
 		status = "okay";
+		system-power-controller;
 
 		pinctrl-names = "default";
 		pinctrl-0 = <&act8846_dvs0_ctl>;

arch/arm/boot/dts/rk3288-evb.dtsi

@@ -112,6 +112,23 @@
 		regulator-always-on;
 		regulator-boot-on;
 	};
+
+	/*
+	 * NOTE: vcc_sd isn't hooked up on v1.0 boards where power comes from
+	 * vcc_io directly.  Those boards won't be able to power cycle SD cards
+	 * but it shouldn't hurt to toggle this pin there anyway.
+	 */
+	vcc_sd: sdmmc-regulator {
+		compatible = "regulator-fixed";
+		gpio = <&gpio7 11 GPIO_ACTIVE_LOW>;
+		pinctrl-names = "default";
+		pinctrl-0 = <&sdmmc_pwr>;
+		regulator-name = "vcc_sd";
+		regulator-min-microvolt = <3300000>;
+		regulator-max-microvolt = <3300000>;
+		startup-delay-us = <100000>;
+		vin-supply = <&vcc_io>;
+	};
 };
 
 &emmc {
@@ -141,6 +158,8 @@
 	pinctrl-names = "default";
 	pinctrl-0 = <&sdmmc_clk &sdmmc_cmd &sdmmc_cd &sdmmc_bus4>;
 	status = "okay";
+	vmmc-supply = <&vcc_sd>;
+	vqmmc-supply = <&vccio_sd>;
 };
 
 &i2c0 {
@@ -232,6 +251,10 @@
 		sdmmc_cmd: sdmmc-cmd {
 			rockchip,pins = <6 21 RK_FUNC_1 &pcfg_pull_up_drv_8ma>;
 		};
+
+		sdmmc_pwr: sdmmc-pwr {
+			rockchip,pins = <7 11 RK_FUNC_GPIO &pcfg_pull_none>;
+		};
 	};
 
 	usb {

arch/arm/boot/dts/rk3288-firefly.dtsi

@@ -246,6 +246,14 @@
 		pinctrl-0 = <&pmic_vsel>, <&pwr_hold>;
 		system-power-controller;
 
+		vp1-supply = <&vcc_sys>;
+		vp2-supply = <&vcc_sys>;
+		vp3-supply = <&vcc_sys>;
+		vp4-supply = <&vcc_sys>;
+		inl1-supply = <&vcc_sys>;
+		inl2-supply = <&vcc_sys>;
+		inl3-supply = <&vcc_20>;
+
 		regulators {
 			vcc_ddr: REG1 {
 				regulator-name = "vcc_ddr";
@@ -457,6 +465,12 @@
 	status = "okay";
 };
 
+&tsadc {
+	rockchip,hw-tshut-mode = <0>;
+	rockchip,hw-tshut-polarity = <0>;
+	status = "okay";
+};
+
 &uart0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart0_xfer>, <&uart0_cts>, <&uart0_rts>;

arch/arm/boot/dts/rk3288-popmetal.dts

@@ -406,6 +406,12 @@
 	};
 };
 
+&tsadc {
+	rockchip,hw-tshut-mode = <0>;
+	rockchip,hw-tshut-polarity = <0>;
+	status = "okay";
+};
+
 &vopb {
 	status = "okay";
 };

arch/arm/boot/dts/rk3288.dtsi

@@ -44,6 +44,14 @@
 		spi2 = &spi2;
 	};
 
+	arm-pmu {
+		compatible = "arm,cortex-a12-pmu";
+		interrupts = <GIC_SPI 151 IRQ_TYPE_LEVEL_HIGH>,
+			     <GIC_SPI 152 IRQ_TYPE_LEVEL_HIGH>,
+			     <GIC_SPI 153 IRQ_TYPE_LEVEL_HIGH>,
+			     <GIC_SPI 154 IRQ_TYPE_LEVEL_HIGH>;
+	};
+
 	cpus {
 		#address-cells = <1>;
 		#size-cells = <0>;
@@ -434,6 +442,7 @@
 		interrupts = <GIC_SPI 25 IRQ_TYPE_LEVEL_HIGH>;
 		clocks = <&cru HCLK_USBHOST1>;
 		clock-names = "otg";
+		dr_mode = "host";
 		phys = <&usbphy2>;
 		phy-names = "usb2-phy";
 		status = "disabled";
@@ -446,6 +455,11 @@
 		interrupts = <GIC_SPI 23 IRQ_TYPE_LEVEL_HIGH>;
 		clocks = <&cru HCLK_OTG0>;
 		clock-names = "otg";
+		dr_mode = "otg";
+		g-np-tx-fifo-size = <16>;
+		g-rx-fifo-size = <275>;
+		g-tx-fifo-size = <256 128 128 64 64 32>;
+		g-use-dma;
 		phys = <&usbphy0>;
 		phy-names = "usb2-phy";
 		status = "disabled";