ARM: dts: at91: sama5d27_som1_ek: update pinmux/pinconf for LEDs and USB

There are some changes from the prototype board concerning LEDs and USB
pins:
- USBB power enable and red LED pins are inverted.
- The polarity of LEDs is inverted too.
Signed-off-by: NLudovic Desroches <ludovic.desroches@microchip.com>
Signed-off-by: NClaudiu Beznea <claudiu.beznea@microchip.com>
Signed-off-by: NNicolas Ferre <nicolas.ferre@microchip.com>

arch/arm/boot/dts/at91-sama5d27_som1_ek.dts

@@ -67,7 +67,7 @@
 
 		usb1: ohci@00400000 {
 			num-ports = <3>;
-			atmel,vbus-gpio = <&pioA PIN_PA10 GPIO_ACTIVE_HIGH>;
+			atmel,vbus-gpio = <&pioA PIN_PA27 GPIO_ACTIVE_HIGH>;
 			pinctrl-names = "default";
 			pinctrl-0 = <&pinctrl_usb_default>;
 			status = "okay";
@@ -330,7 +330,7 @@
 				};
 
 				pinctrl_led_gpio_default: led_gpio_default {
-					pinmux = <PIN_PA27__GPIO>,
+					pinmux = <PIN_PA10__GPIO>,
 						 <PIN_PB1__GPIO>,
 						 <PIN_PA31__GPIO>;
 					bias-pull-up;
@@ -396,7 +396,7 @@
 				};
 
 				pinctrl_usb_default: usb_default {
-					pinmux = <PIN_PA10__GPIO>,
+					pinmux = <PIN_PA27__GPIO>,
 						 <PIN_PD19__GPIO>;
 					bias-disable;
 				};
@@ -520,17 +520,17 @@
 
 		red {
 			label = "red";
-			gpios = <&pioA PIN_PA27 GPIO_ACTIVE_LOW>;
+			gpios = <&pioA PIN_PA10 GPIO_ACTIVE_HIGH>;
 		};
 
 		green {
 			label = "green";
-			gpios = <&pioA PIN_PB1 GPIO_ACTIVE_LOW>;
+			gpios = <&pioA PIN_PB1 GPIO_ACTIVE_HIGH>;
 		};
 
 		blue {
 			label = "blue";
-			gpios = <&pioA PIN_PA31 GPIO_ACTIVE_LOW>;
+			gpios = <&pioA PIN_PA31 GPIO_ACTIVE_HIGH>;
 			linux,default-trigger = "heartbeat";
 		};
 	};