Ethernut 5 board support

Add support for the Ethernut 5 open hardware design, based
on Atmel's AT91SAM9XE512 SoC.
Signed-off-by: NTim Schendekehl <tim.schendekehl@egnite.de>

arch/arm/boot/dts/ethernut5.dts

+/*
+ * ethernut5.dts - Device Tree file for Ethernut 5 board
+ *
+ * Copyright (C) 2012 egnite GmbH <info@egnite.de>
+ *
+ * Licensed under GPLv2.
+ */
+/dts-v1/;
+/include/ "at91sam9260.dtsi"
+
+/ {
+	model = "Ethernut 5";
+	compatible = "egnite,ethernut5", "atmel,at91sam9260", "atmel,at91sam9";
+
+	chosen {
+		bootargs = "console=ttyS0,115200 root=/dev/mtdblock0 rw rootfstype=jffs2";
+	};
+
+	memory {
+		reg = <0x20000000 0x08000000>;
+	};
+
+	ahb {
+		apb {
+			dbgu: serial@fffff200 {
+				status = "okay";
+			};
+
+			usart0: serial@fffb0000 {
+				status = "okay";
+			};
+
+			usart1: serial@fffb4000 {
+				status = "okay";
+			};
+
+			macb0: ethernet@fffc4000 {
+				phy-mode = "rmii";
+				status = "okay";
+			};
+
+			usb1: gadget@fffa4000 {
+				atmel,vbus-gpio = <&pioC 5 0>;
+				status = "okay";
+			};
+		};
+
+		nand0: nand@40000000 {
+			nand-bus-width = <8>;
+			nand-ecc-mode = "soft";
+			nand-on-flash-bbt;
+			status = "okay";
+
+			gpios = <0
+				 &pioC 14 0
+				 0
+				>;
+
+			root@0 {
+				label = "root";
+				reg = <0x0 0x08000000>;
+			};
+
+			data@20000 {
+				label = "data";
+				reg = <0x08000000 0x38000000>;
+			};
+		};
+
+		usb0: ohci@00500000 {
+			num-ports = <2>;
+			status = "okay";
+		};
+	};
+
+	i2c@0 {
+		status = "okay";
+
+		pcf8563@50 {
+			compatible = "nxp,pcf8563";
+			reg = <0x51>;
+		};
+	};
+};

arch/arm/mach-at91/Makefile.boot

@@ -15,6 +15,7 @@ endif
 
 # Keep dtb files sorted alphabetically for each SoC
 # sam9260
+dtb-$(CONFIG_MACH_AT91SAM_DT) += ethernut5.dtb
 dtb-$(CONFIG_MACH_AT91SAM_DT) += tny_a9260.dtb
 dtb-$(CONFIG_MACH_AT91SAM_DT) += usb_a9260.dtb
 # sam9263