hpsa: change how SA controllers are reset

Change how SA controllers are reset by changing PCI power levels.
The hpsa driver was finding the PCI_PM_CTRL_STATE_MASK offset
then reading/writing a bitmask to change the power state. There
are kernel functions that do the same operations. Better to use
the kernel functions.
Signed-off-by: NDon Brace <don.brace@pmcs.com>
Reviewed-by: NScott Teel <scott.teel@pmcs.com>
Reviewed-by: NWebb Scales <webbnh@hp.com>
Signed-off-by: NChristoph Hellwig <hch@lst.de>

drivers/scsi/hpsa.c

@@ -5689,30 +5689,22 @@ static int hpsa_controller_hard_reset(struct pci_dev *pdev,
 		 * the controller, place the interface device in D3 then to D0,
 		 * this causes a secondary PCI reset which will reset the
 		 * controller." */
-		int pos;
-		u16 pmcsr;
-
-		pos = pci_find_capability(pdev, PCI_CAP_ID_PM);
-		if (pos == 0) {
-			dev_err(&pdev->dev,
-				"hpsa_reset_controller: "
-				"PCI PM not supported\n");
-			return -ENODEV;
-		}
+
+		int rc = 0;
+
 		dev_info(&pdev->dev, "using PCI PM to reset controller\n");
+
 		/* enter the D3hot power management state */
-		pci_read_config_word(pdev, pos + PCI_PM_CTRL,
-					(__force u16 *)&pmcsr);
-		pmcsr &= ~PCI_PM_CTRL_STATE_MASK;
-		pmcsr |= (__force u16) PCI_D3hot;
-		pci_write_config_word(pdev, pos + PCI_PM_CTRL, pmcsr);
+		rc = pci_set_power_state(pdev, PCI_D3hot);
+		if (rc)
+			return rc;
 
 		msleep(500);
 
 		/* enter the D0 power management state */
-		pmcsr &= ~PCI_PM_CTRL_STATE_MASK;
-		pmcsr |= (__force u16) PCI_D0;
-		pci_write_config_word(pdev, pos + PCI_PM_CTRL, pmcsr);
+		rc = pci_set_power_state(pdev, PCI_D0);
+		if (rc)
+			return rc;
 
 		/*
 		 * The P600 requires a small delay when changing states.