usb: dwc3: core: switch to snps,dwc3

all other drivers using Synopsys IPs with DT
have a compatible of snps,$driver, in order
to add consistency, we are switching over to
snps,dwc3 but keeping synopsys,dwc3 in the core
driver to maintain backwards compatibility.

New DTS bindings should NOT use synopsys,dwc3.
Signed-off-by: NFelipe Balbi <balbi@ti.com>

Documentation/devicetree/bindings/usb/dwc3.txt

@@ -3,7 +3,7 @@ synopsys DWC3 CORE
 DWC3- USB3 CONTROLLER
 
 Required properties:
- - compatible: must be "synopsys,dwc3"
+ - compatible: must be "snps,dwc3"
  - reg : Address and length of the register set for the device
  - interrupts: Interrupts used by the dwc3 controller.
  - usb-phy : array of phandle for the PHY device
@@ -14,7 +14,7 @@ Optional properties:
 This is usually a subnode to DWC3 glue to which it is connected.
 
 dwc3@4a030000 {
-	compatible = "synopsys,dwc3";
+	compatible = "snps,dwc3";
 	reg = <0x4a030000 0xcfff>;
 	interrupts = <0 92 4>
 	usb-phy = <&usb2_phy>, <&usb3,phy>;

arch/arm/boot/dts/omap5.dtsi

@@ -644,7 +644,7 @@
 			utmi-mode = <2>;
 			ranges;
 			dwc3@4a030000 {
-				compatible = "synopsys,dwc3";
+				compatible = "snps,dwc3";
 				reg = <0x4a030000 0x1000>;
 				interrupts = <GIC_SPI 92 IRQ_TYPE_LEVEL_HIGH>;
 				usb-phy = <&usb2_phy>, <&usb3_phy>;

drivers/usb/dwc3/core.c

@@ -734,6 +734,9 @@ static const struct dev_pm_ops dwc3_dev_pm_ops = {
 
 #ifdef CONFIG_OF
 static const struct of_device_id of_dwc3_match[] = {
+	{
+		.compatible = "snps,dwc3"
+	},
 	{
 		.compatible = "synopsys,dwc3"
 	},