net: qcom/emac: Reduce timeout for mdio read/write

Currently mdio read/write takes around ~115us as the timeout
between status check is set to 100us.
By reducing the timeout to 1us mdio read/write takes ~15us to
complete. This improves the link up event response.
Signed-off-by: NHemanth Puranik <hpuranik@codeaurora.org>
Acked-by: NTimur Tabi <timur@codeaurora.org>
Reviewed-by: NAndrew Lunn <andrew@lunn.ch>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/qualcomm/emac/emac-phy.c

@@ -47,6 +47,7 @@
 #define MDIO_CLK_25_28                                               7
 
 #define MDIO_WAIT_TIMES                                           1000
+#define MDIO_STATUS_DELAY_TIME                                       1
 
 static int emac_mdio_read(struct mii_bus *bus, int addr, int regnum)
 {
@@ -65,7 +66,7 @@ static int emac_mdio_read(struct mii_bus *bus, int addr, int regnum)
 
 	if (readl_poll_timeout(adpt->base + EMAC_MDIO_CTRL, reg,
 			       !(reg & (MDIO_START | MDIO_BUSY)),
-			       100, MDIO_WAIT_TIMES * 100))
+			       MDIO_STATUS_DELAY_TIME, MDIO_WAIT_TIMES * 100))
 		return -EIO;
 
 	return (reg >> MDIO_DATA_SHFT) & MDIO_DATA_BMSK;
@@ -88,8 +89,8 @@ static int emac_mdio_write(struct mii_bus *bus, int addr, int regnum, u16 val)
 	writel(reg, adpt->base + EMAC_MDIO_CTRL);
 
 	if (readl_poll_timeout(adpt->base + EMAC_MDIO_CTRL, reg,
-			       !(reg & (MDIO_START | MDIO_BUSY)), 100,
-			       MDIO_WAIT_TIMES * 100))
+			       !(reg & (MDIO_START | MDIO_BUSY)),
+			       MDIO_STATUS_DELAY_TIME, MDIO_WAIT_TIMES * 100))
 		return -EIO;
 
 	return 0;