Skip to content

Q
qemu

openeuler / qemu

通知 10
Star 0
Fork 0
Q
qemu

体验新版 GitCode，发现更多精彩内容 >>

切换分支/标签
  1. 30 11月, 2008 4 次提交
  3. 26 11月, 2008 1 次提交
  5. 25 11月, 2008 4 次提交
  7. 22 11月, 2008 3 次提交
    • A
      SH4: Switch serial emulation to qemu_irq · 4e7ed2d1
      由 aurel32 提交于 
      This patches makes SH serial emulation use qemu_irq in its interface.

        * hw/sh.h (sh_serial_init): Take qemu_irq, not intc_source.
        * hw/sh7750.c (sh7750_init): Adjust.
        * hw/sh_intc.c (sh_intc_set_irq): Don't assert or deassert
        irq more than once.
        * hw/sh_serial.c (sh_serial_state): Use qemu_irq, not intc_source.
        (sh_serial_clear_fifo, sh_serial_ioport_write)
        (sh_serial_receive_byte): Adjust.
        (sh_serial_init): Take qemu_irq, not intc_source.

(Vladimir Prus)

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5769 c046a42c-6fe2-441c-8c8c-71466251a162
      4e7ed2d1
    • A
      SH4: Use qemu_irq in timer emulation. · 96e2fc41
      由 aurel32 提交于 
              * hw/sh.h (tmu012_init): Accept qemu_irq, not intc_source.
        * hw/sh7750.c (sh7750_init): Pass qemu_irq to tmu012_init.
        * hw/sh_intc.c (sh_intc_set_irq): New.
        (sh_intc_init): Allocate irqs.
        * hw/sh_intc.h (struct intc_desc): New field irqs.
        * hw/sh_timer.c (sh_timer_state): Use qemu_irq, not intc_source.
        (sh_timer_update): Use qemu_set_irq, not sh_intc_toggle_source.
        (sh_timer_init, tmu012_init): Adjust.

(Vladimir Prus)

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5768 c046a42c-6fe2-441c-8c8c-71466251a162
      96e2fc41
    • A
      e1000 VLAN offload emulation (Alex Williamson) · 8f2e8d1f
      由 aliguori 提交于 
      We're currently ignoring the e1000 VLAN tagging, stripping and filtering
features in the e1000 emulation.  This patch adds backing for the
relevant registers and provides a software implementation of the
acceleration, such that a guest can make use of VLANs.

This is mostly (only?) useful for a guest on a bridge (not user mode
networking).  The only caveat beyond that is that you need to make sure
the host NIC isn't doing it's own tagging, stripping, or filtering.
This generally means the host NIC on the bridge should not be part of a
VLAN.
Signed-off-by: NAlex Williamson <alex.williamson@hp.com>
Signed-off-by: NAnthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5766 c046a42c-6fe2-441c-8c8c-71466251a162
      8f2e8d1f
  9. 21 11月, 2008 3 次提交
  11. 19 11月, 2008 2 次提交
  13. 14 11月, 2008 2 次提交
  15. 13 11月, 2008 2 次提交
    • B
      Don't use "hz" in identifiers to make AIX happy. · b0f74c87
      由 balrog 提交于 
      malc found AIX headers leak "hz" and so it can't be used there.  Change
the occurences in hw/.


git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5709 c046a42c-6fe2-441c-8c8c-71466251a162
      b0f74c87
    • B
      Implement LSI53C895A quirks exposed by OpenServer (Justin Chevrier). · 9167a69a
      由 balrog 提交于 
      After going through the debug log and scratching my head for quite some
time. I found the following:

The problem was with this block move:

lsi_scsi: SCRIPTS dsp=0fae8e50 opcode 01000028 arg 00f63c40
lsi_scsi: DMA addr=0x00f63c40 len=36

The number of bytes to be transferred (len) should be 40 which corresponds
to the block transfer of length 0x28 (from opcode 01000028). Instead we
have a length of 36 (0x24). The code responsible for this is (in
'lsi_do_dma'):

if (count > s->current_dma_len)
   count = s->current_dma_len;

Basically we're overwriting the length 40 with the value 36 which I
think we just left over in that variable from an earlier transfer. In my
patch below I initialize s->current_dma_len to s->dbc before we begin
the DMA transfer during Data In phase.

The attached patch gets Openserver 5.0.5 past the hardware detection
(and it lists the hard drive to boot, woohoo). It appears to stop a
little while later (doesn't seem SCSI related), but it's been so long since
I've booted Openserver I'm not sure what's supposted to happen after the HW
detection using the boot/root disks.

Props go to Craig Ringer for the initial post and the code that he posted
some of which is in this patch.


git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5706 c046a42c-6fe2-441c-8c8c-71466251a162
      9167a69a
  17. 12 11月, 2008 3 次提交
  19. 11 11月, 2008 3 次提交
  21. 09 11月, 2008 4 次提交
  23. 08 11月, 2008 1 次提交
  25. 06 11月, 2008 3 次提交
    • B
      SM501 emulation for R2D-SH4 · ffd39257
      由 blueswir1 提交于 
      This patch adds minimum emulation of SM501 multifunction device,
whose main feature is 2D graphics.  It is one of the peripheral
of R2D, the SH4 evaluation board.  We can see TUX printed on the
QEMU console.
Signed-off-by: NShin-ichiro KAWASAKI <kawasaki@juno.dti.ne.jp>


git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5632 c046a42c-6fe2-441c-8c8c-71466251a162
      ffd39257
    • B
      Use qemu_ram_alloc · 5c6602c5
      由 blueswir1 提交于 
      git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5630 c046a42c-6fe2-441c-8c8c-71466251a162
      5c6602c5
    • A
      Add KVM support to QEMU · 7ba1e619
      由 aliguori 提交于 
      This patch adds very basic KVM support.  KVM is a kernel module for Linux that
allows userspace programs to make use of hardware virtualization support.  It
current supports x86 hardware virtualization using Intel VT-x or AMD-V.  It
also supports IA64 VT-i, PPC 440, and S390.

This patch only implements the bare minimum support to get a guest booting.  It
has very little impact the rest of QEMU and attempts to integrate nicely with
the rest of QEMU.

Even though this implementation is basic, it is significantly faster than TCG.
Booting and shutting down a Linux guest:

w/TCG:  1:32.36 elapsed  84% CPU

w/KVM:  0:31.14 elapsed  59% CPU

Right now, KVM is disabled by default and must be explicitly enabled with
 -enable-kvm.  We can enable it by default later when we have had better
testing.
Signed-off-by: NAnthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5627 c046a42c-6fe2-441c-8c8c-71466251a162
      7ba1e619
  27. 05 11月, 2008 2 次提交
  29. 04 11月, 2008 3 次提交