- 23 9月, 2016 4 次提交
-
-
由 Cédric Le Goater 提交于
Configure the size of the RAM of the SOC using a property to propagate the value down to the memory controller from the board level. Signed-off-by: NCédric Le Goater <clg@kaod.org> Reviewed-by: NAndrew Jeffery <andrew@aj.id.au> Message-id: 1473438177-26079-14-git-send-email-clg@kaod.org Signed-off-by: NPeter Maydell <peter.maydell@linaro.org>
-
由 Cédric Le Goater 提交于
Also change the default value used in case of an error. The minimum size is a bit severe, so let's just use an average RAM size. Signed-off-by: NCédric Le Goater <clg@kaod.org> Message-id: 1473438177-26079-13-git-send-email-clg@kaod.org Signed-off-by: NPeter Maydell <peter.maydell@linaro.org>
-
由 Cédric Le Goater 提交于
There is no need to do this at each reset as the RAM size will not change. Signed-off-by: NCédric Le Goater <clg@kaod.org> Reviewed-by: NAndrew Jeffery <andrew@aj.id.au> Message-id: 1473438177-26079-12-git-send-email-clg@kaod.org Signed-off-by: NPeter Maydell <peter.maydell@linaro.org>
-
由 Cédric Le Goater 提交于
Based on previous work done by Andrew Jeffery <andrew@aj.id.au>. Signed-off-by: NCédric Le Goater <clg@kaod.org> Reviewed-by: NAndrew Jeffery <andrew@aj.id.au> Reviewed-by: NPeter Maydell <peter.maydell@linaro.org> Message-id: 1473438177-26079-9-git-send-email-clg@kaod.org Signed-off-by: NPeter Maydell <peter.maydell@linaro.org>
-
- 07 9月, 2016 1 次提交
-
-
由 Cédric Le Goater 提交于
The uboot in the previous release of the SDK was using a hardcoded value for memory size. This is not true anymore, the value is now retrieved from the memory controller. Below is a model for this device, only supporting unlock and configuration. Without it, we endup running a guest with 64MB, which is a bit low nowdays. It uses a 'silicon-rev' property and ram_size to build a default value. Some bits should be linked to SCU strapping registers but it seems a bit complex to add for the current need. The model is ready for the AST2500 SOC. Signed-off-by: NCédric Le Goater <clg@kaod.org> Reviewed-by: NPeter Maydell <peter.maydell@linaro.org> Signed-off-by: NPeter Maydell <peter.maydell@linaro.org>
-