Skip to content

Q
qemu

openeuler / qemu

通知 10
Star 0
Fork 0
Q
qemu

体验新版 GitCode，发现更多精彩内容 >>

切换分支/标签
  1. 23 5月, 2017 1 次提交
  3. 31 3月, 2017 1 次提交
  5. 18 2月, 2017 1 次提交
  7. 14 2月, 2017 1 次提交
  9. 10 1月, 2017 2 次提交
  11. 15 11月, 2016 3 次提交
  13. 10 10月, 2016 5 次提交
  15. 27 9月, 2016 1 次提交
    • M
      virtio-net: allow increasing rx queue size · 1c0fbfa3
      由 Michael S. Tsirkin 提交于 
      This allows increasing the rx queue size up to 1024: unlike with tx,
guests don't put in huge S/G lists into RX so the risk of running into
the max 1024 limitation due to some off-by-one seems small.

It's helpful for users like OVS-DPDK which don't do any buffering on the
host - 1K roughly matches 500 entries in tun + 256 in the current rx
queue, which seems to work reasonably well. We could probably make do
with ~750 entries but virtio spec limits us to powers of two.
It might be a good idea to specify an s/g size limit in a future
version.

It also might be possible to make the queue size smaller down the road, 64
seems like the minimal value which will still work (as guests seem to
assume a queue full of 1.5K buffers is enough to process the largest
incoming packet, which is ~64K).  No one actually asked for this, and
with virtio 1 guests can reduce ring size without need for host
configuration, so don't bother with this for now.

Cc: Cornelia Huck <cornelia.huck@de.ibm.com>
Cc: Jason Wang <jasowang@redhat.com>
Suggested-by: NPatrik Hermansson <phermansson@gmail.com>
Signed-off-by: NMichael S. Tsirkin <mst@redhat.com>
Reviewed-by: NCornelia Huck <cornelia.huck@de.ibm.com>
Signed-off-by: NJason Wang <jasowang@redhat.com>
      1c0fbfa3
  17. 22 7月, 2016 2 次提交
  19. 20 7月, 2016 1 次提交
    • E
      qapi: Change Netdev into a flat union · f394b2e2
      由 Eric Blake 提交于 
      This is a mostly-mechanical conversion that creates a new flat
union 'Netdev' QAPI type that covers all the branches of the
former 'NetClientOptions' simple union, where the branches are
now listed in a new 'NetClientDriver' enum rather than generated
from the simple union.  The existence of a flat union has no
change to the command line syntax accepted for new code, and
will make it possible for a future patch to switch the QMP
command to parse a boxed union for no change to valid QMP; but
it does have some ripple effect on the C code when dealing with
the new types.

While making the conversion, note that the 'NetLegacy' type
remains unchanged: it applies only to legacy command line options,
and will not be ported to QMP, so it should remain a wrapper
around a simple union; to avoid confusion, the type named
'NetClientOptions' is now gone, and we introduce 'NetLegacyOptions'
in its place.  Then, in the C code, we convert from NetLegacy to
Netdev as soon as possible, so that the bulk of the net stack
only has to deal with one QAPI type, not two.  Note that since
the old legacy code always rejected 'hubport', we can just omit
that branch from the new 'NetLegacyOptions' simple union.

Based on an idea originally by Zoltán Kővágó <DirtY.iCE.hu@gmail.com>:
Message-Id: <01a527fbf1a5de880091f98cf011616a78adeeee.1441627176.git.DirtY.iCE.hu@gmail.com>
although the sed script in that patch no longer applies due to
other changes in the tree since then, and I also did some manual
cleanups (such as fixing whitespace to keep checkpatch happy).
Signed-off-by: NEric Blake <eblake@redhat.com>
Message-Id: <1468468228-27827-13-git-send-email-eblake@redhat.com>
Reviewed-by: NMarkus Armbruster <armbru@redhat.com>
[Fixup from Eric squashed in]
Signed-off-by: NMarkus Armbruster <armbru@redhat.com>
      f394b2e2
  21. 04 7月, 2016 1 次提交
  23. 27 6月, 2016 1 次提交
  25. 16 2月, 2016 1 次提交
    • G
      virtio-net: use the backend cross-endian capabilities · 1bfa316c
      由 Greg Kurz 提交于 
      When running a fully emulated device in cross-endian conditions, including
a virtio 1.0 device offered to a big endian guest, we need to fix the vnet
headers. This is currently handled by the virtio_net_hdr_swap() function
in the core virtio-net code but it should actually be handled by the net
backend.

With this patch, virtio-net now tries to configure the backend to do the
endian fixing when the device starts (i.e. drivers sets the CONFIG_OK bit).
If the backend cannot support the requested endiannes, we have to fallback
onto virtio_net_hdr_swap(): this is recorded in the needs_vnet_hdr_swap flag,
to be used in the TX and RX paths.

Note that we reset the backend to the default behaviour (guest native
endianness) when the device stops (i.e. device status had CONFIG_OK bit and
driver unsets it). This is needed, with the linux tap backend at least,
otherwise the guest may lose network connectivity if rebooted into a
different endianness.

The current vhost-net code also tries to configure net backends. This will
be no more needed and will be reverted in a subsequent patch.
Reviewed-by: NCornelia Huck <cornelia.huck@de.ibm.com>
Reviewed-by: NLaurent Vivier <lvivier@redhat.com>
Signed-off-by: NGreg Kurz <gkurz@linux.vnet.ibm.com>
Reviewed-by: NMichael S. Tsirkin <mst@redhat.com>
Signed-off-by: NMichael S. Tsirkin <mst@redhat.com>
Reviewed-by: NLaurent Vivier <lvivier@redhat.com>
      1bfa316c
  27. 07 2月, 2016 1 次提交
    • P
      virtio: move allocation to virtqueue_pop/vring_pop · 51b19ebe
      由 Paolo Bonzini 提交于 
      The return code of virtqueue_pop/vring_pop is unused except to check for
errors or 0.  We can thus easily move allocation inside the functions
and just return a pointer to the VirtQueueElement.

The advantage is that we will be able to allocate only the space that
is needed for the actual size of the s/g list instead of the full
VIRTQUEUE_MAX_SIZE items.  Currently VirtQueueElement takes about 48K
of memory, and this kind of allocation puts a lot of stress on malloc.
By cutting the size by two or three orders of magnitude, malloc can
use much more efficient algorithms.

The patch is pretty large, but changes to each device are testable
more or less independently.  Splitting it would mostly add churn.
Signed-off-by: NPaolo Bonzini <pbonzini@redhat.com>
Reviewed-by: NMichael S. Tsirkin <mst@redhat.com>
Signed-off-by: NMichael S. Tsirkin <mst@redhat.com>
Reviewed-by: NCornelia Huck <cornelia.huck@de.ibm.com>
      51b19ebe
  29. 29 1月, 2016 1 次提交
  31. 01 10月, 2015 1 次提交
  33. 24 9月, 2015 2 次提交
  35. 10 9月, 2015 1 次提交
  37. 13 8月, 2015 1 次提交
  39. 27 7月, 2015 2 次提交
  41. 20 7月, 2015 3 次提交
  43. 13 7月, 2015 1 次提交
  45. 19 6月, 2015 1 次提交
  47. 11 6月, 2015 4 次提交
  49. 04 6月, 2015 1 次提交