The SGI IOC4 I/O controller chip drivers are currently all configured by
CONFIG_BLK_DEV_SGIIOC4.  This is undesirable as not all IOC4 hardware features
are needed by all systems.

This patch adds two configuration variables, CONFIG_SGI_IOC4 for core IOC4
driver support (see patch 1/3 in this series for further explanation) and
CONFIG_SERIAL_SGI_IOC4 to independently enable serial port support.
Signed-off-by: NBrent Casavant <bcasavan@sgi.com>
Acked-by: NPat Gefre <pfg@sgi.com>
Acked-by: NJeremy Higdon <jeremy@sgi.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Refresh arch/ia64/defconfig, as it was getting a bit stale.  The only
manual changes I made were:

CONFIG_SCSI_SATA=y		needed for some Altix base I/O cards
CONFIG_SCSI_SATA_VITESSE=y

CONFIG_DM_MULTIPATH=m		the rest are already modules

CONFIG_FUSION_SPI=y		new driver breakout
CONFIG_FUSION_FC=m

CONFIG_SGI_TIOCX=y		enable some other SGI drivers
CONFIG_SGI_MBCS=m
CONFIG_AGP_SGI_TIOCA=m

Boot tested on Altix, HP rx2600 and Intel Tiger
Signed-off-by: NGreg Edwards <edwardsg@sgi.com>
Signed-off-by: NTony Luck <tony.luck@intel.com>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!