Skip to content

K
Kernel

openeuler / Kernel
接近 2 年 前同步成功

通知 8
Star 0
Fork 0
K
Kernel
切换分支/标签
  1. 09 10月, 2017 1 次提交
  3. 10 9月, 2017 2 次提交
    • R
      sparc64: Handle additional cases of no fault loads · b6fe1089
      由 Rob Gardner 提交于 
      Load instructions using ASI_PNF or other no-fault ASIs should not
cause a SIGSEGV or SIGBUS.

A garden variety unmapped address follows the TSB miss path, and when
no valid mapping is found in the process page tables, the miss handler
checks to see if the access was via a no-fault ASI.  It then fixes up
the target register with a zero, and skips the no-fault load
instruction.

But different paths are taken for data access exceptions and alignment
traps, and these do not respect the no-fault ASI. We add checks in
these paths for the no-fault ASI, and fix up the target register and
TPC just like in the TSB miss case.
Signed-off-by: NRob Gardner <rob.gardner@oracle.com>
Acked-by: NSam Ravnborg <sam@ravnborg.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      b6fe1089
    • A
      sparc64: speed up etrap/rtrap on NG2 and later processors · a7159a87
      由 Anthony Yznaga 提交于 
      For many sun4v processor types, reading or writing a privileged register
has a latency of 40 to 70 cycles.  Use a combination of the low-latency
allclean, otherw, normalw, and nop instructions in etrap and rtrap to
replace 2 rdpr and 5 wrpr instructions and improve etrap/rtrap
performance.  allclean, otherw, and normalw are available on NG2 and
later processors.

The average ticks to execute the flush windows trap ("ta 0x3") with and
without this patch on select platforms:

 CPU            Not patched     Patched    % Latency Reduction

 NG2            1762            1558            -11.58
 NG4            3619            3204            -11.47
 M7             3015            2624            -12.97
 SPARC64-X      829             770              -7.12
Signed-off-by: NAnthony Yznaga <anthony.yznaga@oracle.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      a7159a87
  5. 09 9月, 2017 2 次提交
  7. 29 8月, 2017 2 次提交
  9. 26 8月, 2017 1 次提交
    • J
      futex: Remove duplicated code and fix undefined behaviour · 30d6e0a4
      由 Jiri Slaby 提交于 
      There is code duplicated over all architecture's headers for
futex_atomic_op_inuser. Namely op decoding, access_ok check for uaddr,
and comparison of the result.

Remove this duplication and leave up to the arches only the needed
assembly which is now in arch_futex_atomic_op_inuser.

This effectively distributes the Will Deacon's arm64 fix for undefined
behaviour reported by UBSAN to all architectures. The fix was done in
commit 5f16a046 (arm64: futex: Fix undefined behaviour with
FUTEX_OP_OPARG_SHIFT usage). Look there for an example dump.

And as suggested by Thomas, check for negative oparg too, because it was
also reported to cause undefined behaviour report.

Note that s390 removed access_ok check in d12a2970 ("s390/uaccess:
remove pointless access_ok() checks") as access_ok there returns true.
We introduce it back to the helper for the sake of simplicity (it gets
optimized away anyway).
Signed-off-by: NJiri Slaby <jslaby@suse.cz>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Acked-by: NRussell King <rmk+kernel@armlinux.org.uk>
Acked-by: Michael Ellerman <mpe@ellerman.id.au> (powerpc)
Acked-by: Heiko Carstens <heiko.carstens@de.ibm.com> [s390]
Acked-by: Chris Metcalf <cmetcalf@mellanox.com> [for tile]
Reviewed-by: NDarren Hart (VMware) <dvhart@infradead.org>
Reviewed-by: Will Deacon <will.deacon@arm.com> [core/arm64]
Cc: linux-mips@linux-mips.org
Cc: Rich Felker <dalias@libc.org>
Cc: linux-ia64@vger.kernel.org
Cc: linux-sh@vger.kernel.org
Cc: peterz@infradead.org
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Max Filippov <jcmvbkbc@gmail.com>
Cc: Paul Mackerras <paulus@samba.org>
Cc: sparclinux@vger.kernel.org
Cc: Jonas Bonn <jonas@southpole.se>
Cc: linux-s390@vger.kernel.org
Cc: linux-arch@vger.kernel.org
Cc: Yoshinori Sato <ysato@users.sourceforge.jp>
Cc: linux-hexagon@vger.kernel.org
Cc: Helge Deller <deller@gmx.de>
Cc: "James E.J. Bottomley" <jejb@parisc-linux.org>
Cc: Catalin Marinas <catalin.marinas@arm.com>
Cc: Matt Turner <mattst88@gmail.com>
Cc: linux-snps-arc@lists.infradead.org
Cc: Fenghua Yu <fenghua.yu@intel.com>
Cc: Arnd Bergmann <arnd@arndb.de>
Cc: linux-xtensa@linux-xtensa.org
Cc: Stefan Kristiansson <stefan.kristiansson@saunalahti.fi>
Cc: openrisc@lists.librecores.org
Cc: Ivan Kokshaysky <ink@jurassic.park.msu.ru>
Cc: Stafford Horne <shorne@gmail.com>
Cc: linux-arm-kernel@lists.infradead.org
Cc: Richard Henderson <rth@twiddle.net>
Cc: Chris Zankel <chris@zankel.net>
Cc: Michal Simek <monstr@monstr.eu>
Cc: Tony Luck <tony.luck@intel.com>
Cc: linux-parisc@vger.kernel.org
Cc: Vineet Gupta <vgupta@synopsys.com>
Cc: Ralf Baechle <ralf@linux-mips.org>
Cc: Richard Kuo <rkuo@codeaurora.org>
Cc: linux-alpha@vger.kernel.org
Cc: Martin Schwidefsky <schwidefsky@de.ibm.com>
Cc: linuxppc-dev@lists.ozlabs.org
Cc: "David S. Miller" <davem@davemloft.net>
Link: http://lkml.kernel.org/r/20170824073105.3901-1-jslaby@suse.cz
      30d6e0a4
  11. 22 8月, 2017 1 次提交
    • T
      sparc: kernel/pcic: silence gcc 7.x warning in pcibios_fixup_bus() · 2dc77533
      由 Thomas Petazzoni 提交于 
      When building the kernel for Sparc using gcc 7.x, the build fails
with:

arch/sparc/kernel/pcic.c: In function ‘pcibios_fixup_bus’:
arch/sparc/kernel/pcic.c:647:8: error: ‘cmd’ may be used uninitialized in this function [-Werror=maybe-uninitialized]
    cmd |= PCI_COMMAND_IO;
        ^~

The simplified code looks like this:

unsigned int cmd;
[...]
pcic_read_config(dev->bus, dev->devfn, PCI_COMMAND, 2, &cmd);
[...]
cmd |= PCI_COMMAND_IO;

I.e, the code assumes that pcic_read_config() will always initialize
cmd. But it's not the case. Looking at pcic_read_config(), if
bus->number is != 0 or if the size is not one of 1, 2 or 4, *val will
not be initialized.

As a simple fix, we initialize cmd to zero at the beginning of
pcibios_fixup_bus.
Signed-off-by: NThomas Petazzoni <thomas.petazzoni@free-electrons.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      2dc77533
  13. 17 8月, 2017 3 次提交
  15. 16 8月, 2017 7 次提交
  17. 11 8月, 2017 7 次提交
  19. 10 8月, 2017 7 次提交
  21. 05 8月, 2017 4 次提交
  23. 04 8月, 2017 3 次提交
    • W
      sock: add SOCK_ZEROCOPY sockopt · 76851d12
      由 Willem de Bruijn 提交于 
      The send call ignores unknown flags. Legacy applications may already
unwittingly pass MSG_ZEROCOPY. Continue to ignore this flag unless a
socket opts in to zerocopy.

Introduce socket option SO_ZEROCOPY to enable MSG_ZEROCOPY processing.
Processes can also query this socket option to detect kernel support
for the feature. Older kernels will return ENOPROTOOPT.
Signed-off-by: NWillem de Bruijn <willemb@google.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      76851d12
    • A
      crypto: algapi - make crypto_xor() take separate dst and src arguments · 45fe93df
      由 Ard Biesheuvel 提交于 
      There are quite a number of occurrences in the kernel of the pattern

  if (dst != src)
          memcpy(dst, src, walk.total % AES_BLOCK_SIZE);
  crypto_xor(dst, final, walk.total % AES_BLOCK_SIZE);

or

  crypto_xor(keystream, src, nbytes);
  memcpy(dst, keystream, nbytes);

where crypto_xor() is preceded or followed by a memcpy() invocation
that is only there because crypto_xor() uses its output parameter as
one of the inputs. To avoid having to add new instances of this pattern
in the arm64 code, which will be refactored to implement non-SIMD
fallbacks, add an alternative implementation called crypto_xor_cpy(),
taking separate input and output arguments. This removes the need for
the separate memcpy().
Signed-off-by: NArd Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au>
      45fe93df
    • L
      sparc/PCI: Replace pci_fixup_irqs() call with host bridge IRQ mapping hooks · b483e3c1
      由 Lorenzo Pieralisi 提交于 
      The pci_fixup_irqs() function allocates IRQs for all PCI devices present in
a system; those PCI devices possibly belong to different PCI bus trees (and
possibly rooted at different host bridges) and may well be enabled (ie
probed and bound to a driver) by the time pci_fixup_irqs() is called when
probing a given host bridge driver.

Furthermore, current kernel code relying on pci_fixup_irqs() to assign
legacy PCI IRQs to devices does not work at all for hotplugged devices in
that the code carrying out the IRQ fixup is called at host bridge driver
probe time, which just cannot take into account devices hotplugged after
the system has booted.

The introduction of map/swizzle function hooks in struct pci_host_bridge
allows us to define per-bridge map/swizzle functions that can be used at
device probe time in PCI core code to allocate IRQs for a given device
(through pci_assign_irq()).

Convert PCI host bridge initialization code to the
pci_scan_root_bus_bridge() API (that allows to pass a struct
pci_host_bridge with initialized map/swizzle pointers) and remove the
pci_fixup_irqs() call from arch code.
Signed-off-by: NLorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Signed-off-by: NBjorn Helgaas <bhelgaas@google.com>
Cc: "David S. Miller" <davem@davemloft.net>
      b483e3c1