ADD-IP draft section 5.2 specifies that if an association can not
be found using the source and destination of the IP packet,
then, if the packet contains ASCONF chunks, the Address Parameter
TLV should be used to lookup an association.
Signed-off-by: NVlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The ADD-IP "Set Primary IP Address" parameter is allowed in the
INIT/INIT-ACK exchange.  Allow processing of this parameter during
the INIT/INIT-ACK.
Signed-off-by: NVlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The Address Parameter in the parameter list of the ASCONF chunk
may be a wildcard address.  In this case special processing
is required.  For the 'add' case, the source IP of the packet is
added.  In the 'del' case, all addresses except the source IP
of packet are removed. In the "mark primary" case, the source
address is marked as primary.
Signed-off-by: NVlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Now that we support AUTH, discard unauthenticated ASCONF and ASCONF ACK
chunks as mandated in the ADD-IP spec.
Signed-off-by: NVlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

It appears that I've managed to create two different functions both
called xfrm6_tunnel_output.  This is because we have the plain tunnel
encapsulation named xfrmX_tunnel as well as the tunnel-mode encapsulation
which lives in the files xfrmX_mode_tunnel.c.

This patch renames functions from the latter to use the xfrmX_mode_tunnel
prefix to avoid name-space conflicts.
Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Add a new rate control algorithm based on a PID controller. It samples the
percentage of failed frames over time, feeds the result into the controller and
uses its output to control the TX rate.
Signed-off-by: NMattias Nissler <mattias.nissler@gmx.de>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Move some code out of rc80211_simple since it's probably needed for all rate
selection algorithms, and fix iwlwifi accordingly. While at it, clean up the
rate_control_get_rate() interface.
Signed-off-by: NStefano Brivio <stefano.brivio@polimi.it>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This patch fixes should_drop_frame function to pass in ps poll control
frames required for power save functioanlity. Interface types that do not
have interest for PS POLL frames now drop it in handler.
Signed-off-by: NRon Rindjunsky <ron.rindjunsky@intel.com>
Acked-by: NJohannes Berg <johannes@sipsolutions.net>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The SNMP macros use raw_smp_processor_id() in process context
which is illegal because the process may be preempted and then
migrated to another CPU.

This patch makes it use get_cpu/put_cpu to disable preemption.
Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

While merging the IPsec output path I moved the encapsulation output
operation to the top of the loop so that it sits outside of the locked
section.  Unfortunately in doing so it now sits in front of the space
check as well which could be a fatal error.

This patch rearranges the calls so that the space check happens as
the thing on the output path.

This patch also fixes an incorrect goto should the encapsulation output
fail.

Thanks to Kazunori MIYAZAWA for finding this bug.
Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The NETFILTER_ADVANCED option hides lots of the rather obscure netfilter
options when disabled and provides defaults (M) that should allow to
run a distribution firewall without further thinking.

Defaults to 'y' to avoid breaking current configurations.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Apply Eric Dumazet's jhash optimizations where applicable. Quoting Eric:

Thanks to jhash, hash value uses full 32 bits. Instead of returning
hash % size (implying a divide) we return the high 32 bits of the
(hash * size) that will give results between [0 and size-1] and same
hash distribution.

On most cpus, a multiply is less expensive than a divide, by an order
of magnitude.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This patch generalizes the (CONFIG_IP6_NF_IPTABLES || CONFIG_IP6_NF_IPTABLES_MODULE)
test done in hashlimit_init_dst() to all the xt_hashlimit module.

This permits a size reduction of "struct dsthash_dst". This saves memory and
cpu for IPV4 only hosts.
Signed-off-by: NEric Dumazet <dada1@cosmosbay.com>
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

1) Using jhash2() instead of jhash() is a litle bit faster if applicable.

2) Thanks to jhash, hash value uses full 32 bits.
   Instead of returning hash % size (implying a divide)
   we return the high 32 bits of the (hash * size) that will
   give results between [0 and size-1] and same hash distribution.

  On most cpus, a multiply is less expensive than a divide, by an order
  of magnitude.
Signed-off-by: NEric Dumazet <dada1@cosmosbay.com>
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJan Engelhardt <jengelh@computergmbh.de>
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Parenthesize macro parameters.
Signed-off-by: NJan Engelhardt <jengelh@computergmbh.de>
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

A few netfilter modules provide their own union of IPv4 and IPv6
address storage. Will unify that in this patch series.

(1/4): Rename union nf_conntrack_address to union nf_inet_addr and
move it to x_tables.h.
Signed-off-by: NJan Engelhardt <jengelh@computergmbh.de>
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use %u format specifiers as ->family is unsigned.
Signed-off-by: NJan Engelhardt <jengelh@computergmbh.de>
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

We need to use rcu_assign_pointer/rcu_dereference to avoid races.
Also remove an obsolete CONFIG_IP_NAT_NEEDED ifdef.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Similar to Maciej Soltysiak's ipt_LOG patch, include GID in addition
to UID in netlink message.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Currently we return EINVAL for "instance exists", "allocation failed" and
"module unloaded below us", which is completely inapproriate.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Similar to the nfnetlink_queue fixes:

The peer_pid must be checked in all cases when a logging instance exists,
additionally we must check whether an instance exists before attempting
to configure it to avoid NULL ptr dereferences.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Whatever that comment tries to say, I don't get it and it looks like
a leftover from the time when RCU wasn't used properly.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

nf_nat_setup_info gets the hook number and translates that to the
manip type to perform. This is a relict from the time when one
manip per hook could exist, the exact hook number doesn't matter
anymore, its converted to the manip type. Most callers already
know what kind of NAT they want to perform, so pass the maniptype
in directly.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

When the timer is late its timeout might be before the current time,
in which case a very large value is dumped.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use NLA_PUT_BE32, nla_get_be32() etc.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>