The protection areas boundaries were on 16bit registers, not
8bit. This is consistent with block numbers, which can
extend up to 4096 on bigger chips (and is 2048 on the
docg3).
Signed-off-by: NRobert Jarzmik <robert.jarzmik@free.fr>
Reviewed-by: NIvan Djelic <ivan.djelic@parrot.com>
Reviewed-by: NMike Dunn <mikedunn@newsguy.com>
Signed-off-by: NDavid Woodhouse <David.Woodhouse@intel.com>

Writeb was incorrectly traced as a 16 bits write, instead of
a 8 bits write. Fix it by tracing the correct width.
Signed-off-by: NRobert Jarzmik <robert.jarzmik@free.fr>
Reviewed-by: NIvan Djelic <ivan.djelic@parrot.com>
Reviewed-by: NMike Dunn <mikedunn@newsguy.com>
Signed-off-by: NDavid Woodhouse <David.Woodhouse@intel.com>

Change the NOP debug log verbosity to very verbose to
unburden log analysis.
Signed-off-by: NRobert Jarzmik <robert.jarzmik@free.fr>
Reviewed-by: NIvan Djelic <ivan.djelic@parrot.com>
Reviewed-by: NMike Dunn <mikedunn@newsguy.com>
Signed-off-by: NDavid Woodhouse <David.Woodhouse@intel.com>

Add support for DiskOnChip G3 chips. The support is quite
limited yet :
 - no flash writes/erases are implemented
 - ECC fixes are not implemented
 - powerdown is not implemented
 - IPL handling is not yet done

On the brighter side, the chip reading does work.
Signed-off-by: NRobert Jarzmik <robert.jarzmik@free.fr>