Skip to content

K
Kernel

openeuler / Kernel
1 年多 前同步成功

通知 8
Star 0
Fork 0
K
Kernel
切换分支/标签
  1. 17 8月, 2011 1 次提交
    • J
      xen/x86: replace order-based range checking of M2P table by linear one · ccbcdf7c
      由 Jan Beulich 提交于 
      The order-based approach is not only less efficient (requiring a shift
and a compare, typical generated code looking like this

	mov	eax, [machine_to_phys_order]
	mov	ecx, eax
	shr	ebx, cl
	test	ebx, ebx
	jnz	...

whereas a direct check requires just a compare, like in

	cmp	ebx, [machine_to_phys_nr]
	jae	...

), but also slightly dangerous in the 32-on-64 case - the element
address calculation can wrap if the next power of two boundary is
sufficiently far away from the actual upper limit of the table, and
hence can result in user space addresses being accessed (with it being
unknown what may actually be mapped there).

Additionally, the elimination of the mistaken use of fls() here (should
have been __fls()) fixes a latent issue on x86-64 that would trigger
if the code was run on a system with memory extending beyond the 44-bit
boundary.

CC: stable@kernel.org
Signed-off-by: NJan Beulich <jbeulich@novell.com>
[v1: Based on Jeremy's feedback]
Signed-off-by: NKonrad Rzeszutek Wilk <konrad.wilk@oracle.com>
      ccbcdf7c
  3. 05 8月, 2011 1 次提交
  5. 19 7月, 2011 1 次提交
  7. 16 6月, 2011 1 次提交
  9. 06 6月, 2011 1 次提交
  11. 13 5月, 2011 1 次提交
  13. 06 4月, 2011 2 次提交
  15. 26 2月, 2011 2 次提交
  17. 12 2月, 2011 1 次提交
    • I
      xen: annotate functions which only call into __init at start of day · 44b46c3e
      由 Ian Campbell 提交于 
      Both xen_hvm_init_shared_info and xen_build_mfn_list_list can be
called at resume time as well as at start of day but only reference
__init functions (extend_brk) at start of day. Hence annotate with
__ref.

    WARNING: arch/x86/built-in.o(.text+0x4f1): Section mismatch in reference
        from the function xen_hvm_init_shared_info() to the function
        .init.text:extend_brk()
    The function xen_hvm_init_shared_info() references
    the function __init extend_brk().
    This is often because xen_hvm_init_shared_info lacks a __init
    annotation or the annotation of extend_brk is wrong.

xen_hvm_init_shared_info calls extend_brk() iff !shared_info_page and
initialises shared_info_page with the result. This happens at start of
day only.

    WARNING: arch/x86/built-in.o(.text+0x599b): Section mismatch in reference
        from the function xen_build_mfn_list_list() to the function
        .init.text:extend_brk()
    The function xen_build_mfn_list_list() references
    the function __init extend_brk().
    This is often because xen_build_mfn_list_list lacks a __init
    annotation or the annotation of extend_brk is wrong.

(this warning occurs multiple times)

xen_build_mfn_list_list only calls extend_brk() at boot time, while
building the initial mfn list list
Signed-off-by: NIan Campbell <ian.campbell@citrix.com>
Signed-off-by: NKonrad Rzeszutek Wilk <konrad.wilk@oracle.com>
      44b46c3e
  19. 20 1月, 2011 1 次提交
    • T
      lockdep: Move early boot local IRQ enable/disable status to init/main.c · 2ce802f6
      由 Tejun Heo 提交于 
      During early boot, local IRQ is disabled until IRQ subsystem is
properly initialized.  During this time, no one should enable
local IRQ and some operations which usually are not allowed with
IRQ disabled, e.g. operations which might sleep or require
communications with other processors, are allowed.

lockdep tracked this with early_boot_irqs_off/on() callbacks.
As other subsystems need this information too, move it to
init/main.c and make it generally available.  While at it,
toggle the boolean to early_boot_irqs_disabled instead of
enabled so that it can be initialized with %false and %true
indicates the exceptional condition.
Signed-off-by: NTejun Heo <tj@kernel.org>
Acked-by: NPeter Zijlstra <a.p.zijlstra@chello.nl>
Acked-by: NPekka Enberg <penberg@kernel.org>
Cc: Linus Torvalds <torvalds@linux-foundation.org>
LKML-Reference: <20110120110635.GB6036@htj.dyndns.org>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
      2ce802f6
  21. 10 1月, 2011 1 次提交
  23. 07 1月, 2011 1 次提交
  25. 17 12月, 2010 1 次提交
  27. 30 11月, 2010 2 次提交
    • I
      xen: x86/32: perform initial startup on initial_page_table · 805e3f49
      由 Ian Campbell 提交于 
      Only make swapper_pg_dir readonly and pinned when generic x86 architecture code
(which also starts on initial_page_table) switches to it.  This helps ensure
that the generic setup paths work on Xen unmodified. In particular
clone_pgd_range writes directly to the destination pgd entries and is used to
initialise swapper_pg_dir so we need to ensure that it remains writeable until
the last possible moment during bring up.

This is complicated slightly by the need to avoid sharing kernel PMD entries
when running under Xen, therefore the Xen implementation must make a copy of
the kernel PMD (which is otherwise referred to by both intial_page_table and
swapper_pg_dir) before switching to swapper_pg_dir.
Signed-off-by: NIan Campbell <ian.campbell@citrix.com>
Cc: Borislav Petkov <bp@alien8.de>
Cc: H. Peter Anvin <hpa@linux.intel.com>
Cc: Jeremy Fitzhardinge <jeremy@goop.org>
Signed-off-by: NJeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
      805e3f49
    • J
      xen: don't bother to stop other cpus on shutdown/reboot · 31e323cc
      由 Jeremy Fitzhardinge 提交于 
      Xen will shoot all the VCPUs when we do a shutdown hypercall, so there's
no need to do it manually.

In any case it will fail because all the IPI irqs have been pulled
down by this point, so the cross-CPU calls will simply hang forever.

Until change 76fac077 the function calls
were not synchronously waited for, so this wasn't apparent.  However after
that change the calls became synchronous leading to a hang on shutdown
on multi-VCPU guests.
Signed-off-by: NJeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
Cc: Stable Kernel <stable@kernel.org>
Cc: Alok Kataria <akataria@vmware.com>
      31e323cc
  29. 25 11月, 2010 1 次提交
    • I
      xen: x86/32: perform initial startup on initial_page_table · 5b5c1af1
      由 Ian Campbell 提交于 
      Only make swapper_pg_dir readonly and pinned when generic x86 architecture code
(which also starts on initial_page_table) switches to it.  This helps ensure
that the generic setup paths work on Xen unmodified. In particular
clone_pgd_range writes directly to the destination pgd entries and is used to
initialise swapper_pg_dir so we need to ensure that it remains writeable until
the last possible moment during bring up.

This is complicated slightly by the need to avoid sharing kernel PMD entries
when running under Xen, therefore the Xen implementation must make a copy of
the kernel PMD (which is otherwise referred to by both intial_page_table and
swapper_pg_dir) before switching to swapper_pg_dir.
Signed-off-by: NIan Campbell <ian.campbell@citrix.com>
Tested-by: NKonrad Rzeszutek Wilk <konrad.wilk@oracle.com>
Cc: Borislav Petkov <bp@alien8.de>
Cc: H. Peter Anvin <hpa@linux.intel.com>
Cc: Jeremy Fitzhardinge <jeremy@goop.org>
Signed-off-by: NKonrad Rzeszutek Wilk <konrad.wilk@oracle.com>
      5b5c1af1
  31. 23 11月, 2010 1 次提交
    • K
      xen: set IO permission early (before early_cpu_init()) · ec35a69c
      由 Konrad Rzeszutek Wilk 提交于 
      This patch is based off "xen dom0: Set up basic IO permissions for dom0."
by Juan Quintela <quintela@redhat.com>.

On AMD machines when we boot the kernel as Domain 0 we get this nasty:

mapping kernel into physical memory
Xen: setup ISA identity maps
about to get started...
(XEN) traps.c:475:d0 Unhandled general protection fault fault/trap [#13] on VCPU 0 [ec=0000]
(XEN) domain_crash_sync called from entry.S
(XEN) Domain 0 (vcpu#0) crashed on cpu#0:
(XEN) ----[ Xen-4.1-101116  x86_64  debug=y  Not tainted ]----
(XEN) CPU:    0
(XEN) RIP:    e033:[<ffffffff8130271b>]
(XEN) RFLAGS: 0000000000000282   EM: 1   CONTEXT: pv guest
(XEN) rax: 000000008000c068   rbx: ffffffff8186c680   rcx: 0000000000000068
(XEN) rdx: 0000000000000cf8   rsi: 000000000000c000   rdi: 0000000000000000
(XEN) rbp: ffffffff81801e98   rsp: ffffffff81801e50   r8:  ffffffff81801eac
(XEN) r9:  ffffffff81801ea8   r10: ffffffff81801eb4   r11: 00000000ffffffff
(XEN) r12: ffffffff8186c694   r13: ffffffff81801f90   r14: ffffffffffffffff
(XEN) r15: 0000000000000000   cr0: 000000008005003b   cr4: 00000000000006f0
(XEN) cr3: 0000000221803000   cr2: 0000000000000000
(XEN) ds: 0000   es: 0000   fs: 0000   gs: 0000   ss: e02b   cs: e033
(XEN) Guest stack trace from rsp=ffffffff81801e50:

RIP points to read_pci_config() function.

The issue is that we don't set IO permissions for the Linux kernel early enough.

The call sequence used to be:

    xen_start_kernel()
	x86_init.oem.arch_setup = xen_setup_arch;
        setup_arch:
           - early_cpu_init
               - early_init_amd
                  - read_pci_config
           - x86_init.oem.arch_setup [ xen_arch_setup ]
               - set IO permissions.

We need to set the IO permissions earlier on, which this patch does.
Acked-by: NJeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
Signed-off-by: NKonrad Rzeszutek Wilk <konrad.wilk@oracle.com>
      ec35a69c
  33. 13 11月, 2010 1 次提交
  35. 28 10月, 2010 1 次提交
  37. 23 10月, 2010 5 次提交
  39. 22 10月, 2010 1 次提交
    • A
      x86, kexec: Make sure to stop all CPUs before exiting the kernel · 76fac077
      由 Alok Kataria 提交于 
      x86 smp_ops now has a new op, stop_other_cpus which takes a parameter
"wait" this allows the caller to specify if it wants to stop until all
the cpus have processed the stop IPI.  This is required specifically
for the kexec case where we should wait for all the cpus to be stopped
before starting the new kernel.  We now wait for the cpus to stop in
all cases except for panic/kdump where we expect things to be broken
and we are doing our best to make things work anyway.

This patch fixes a legitimate regression, which was introduced during
2.6.30, by commit id 4ef702c1.
Signed-off-by: NAlok N Kataria <akataria@vmware.com>
LKML-Reference: <1286833028.1372.20.camel@ank32.eng.vmware.com>
Cc: Eric W. Biederman <ebiederm@xmission.com>
Cc: Jeremy Fitzhardinge <jeremy@xensource.com>
Cc: <stable@kernel.org> v2.6.30-36
Signed-off-by: NH. Peter Anvin <hpa@linux.intel.com>
      76fac077
  41. 18 10月, 2010 1 次提交
  43. 12 10月, 2010 1 次提交
  45. 05 8月, 2010 4 次提交
  47. 30 7月, 2010 1 次提交
  49. 27 7月, 2010 3 次提交
  51. 23 7月, 2010 3 次提交