- 23 4月, 2010 4 次提交
-
-
由 Alex Deucher 提交于
DCE4 cards don't have an EnableYUV table. Signed-off-by: NAlex Deucher <alexdeucher@gmail.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Tormod Volden 提交于
Although these cards have 2 pipelines on the silicon only the first passed the QA and the other should be disabled. http://www.digital-daily.com/video/ati-radeon9800se/ http://www.rojakpot.com/showarticle.aspx?artno=101&pgno=1 agd5f: add some other SE cards as well; fix up kms Signed-off-by: NTormod Volden <debian.tormod@gmail.com> Signed-off-by: NAlex Deucher <alexdeucher@gmail.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Dave Airlie 提交于
With evergreen this is bounded by num_crtc not by 0,1. Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Alex Deucher 提交于
Must have gotten broken during an earlier rebase. Signed-off-by: NAlex Deucher <alexdeucher@gmail.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
- 20 4月, 2010 1 次提交
-
-
由 Jesse Barnes 提交于
Drivers may use vblank calls now (e.g. drm_vblank_off) in their unload paths, so don't clean up the vblank related structures until after driver unload. Signed-off-by: NJesse Barnes <jbarnes@virtuousgeek.org> Reviewed-by: NKristian Høgsberg <krh@bitplanet.net> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
- 19 4月, 2010 10 次提交
-
-
由 Dave Airlie 提交于
This is an M24/X600 chip. From RH# 581927 cc: stable@kernel.org Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Marek Olšák 提交于
[airlied: fix V_A_N_V to not be safe and fix check to make sure only r500 - bump userspace version] Signed-off-by: NMarek Olšák <maraeo@gmail.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Corbin Simpson 提交于
Permits MSAA and D3D-style rasterization. [airlied: add rs600] Signed-off-by: NCorbin Simpson <MostAwesomeDude@gmail.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Alex Deucher 提交于
Switching between TV and VGA caused VGA to break on some systems since the TV encoder was left enabled when VGA was used. fixes fdo bug 25520. Signed-off-by: NAlex Deucher <alexdeucher@gmail.com> Cc: stable <stable@kernel.org> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Alex Deucher 提交于
May fix fdo bug 26582. Signed-off-by: NAlex Deucher <alexdeucher@gmail.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Alex Deucher 提交于
On systems with the tv dac shared between DVI and TV, we can only use the dac for one of the connectors. However, when using a digital monitor on the DVI port, you can use the dac for the TV connector just fine. Check the use_digital status when resolving the conflict. Fixes fdo bug 27649, possibly others. Signed-off-by: NAlex Deucher <alexdeucher@gmail.com> Cc: stable <stable@kernel.org> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Alex Deucher 提交于
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Alex Deucher 提交于
Got broken during the evergreen merge. Fixes fdo bug 27001. Signed-off-by: NAlex Deucher <alexdeucher@gmail.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Jerome Glisse 提交于
Typo in in flush leaded to no flush of the RS600 tlb which ultimately leaded to massive system ram corruption, with this patch everythings seems to work properly. Signed-off-by: NJerome Glisse <jglisse@redhat.com> Cc: stable <stable@kernel.org> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Jerome Glisse 提交于
This will help figuring out GPU when looking at bugs log. Signed-off-by: NJerome Glisse <jglisse@redhat.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
- 12 4月, 2010 2 次提交
-
-
由 Marek Olšák 提交于
The 3rd dimension should be minified too. Signed-off-by: NMarek Olšák <maraeo@gmail.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
由 Dave Airlie 提交于
On X startup we were getting a flicker where there shouldn't have been one. the X DDX calls the kernel to set the properties to the same values (yes it could be smarter), however the kernel was doing a pointless modeset then, making my nice smooth boot ugly. Signed-off-by: NDave Airlie <airlied@redhat.com>
-
- 10 4月, 2010 1 次提交
-
-
由 Alex Deucher 提交于
shr/shl ops need the full dst rather than the pre-masked version. Fixes fdo bug 27478 and kernel bug 15738. v2: remove some unsed vars, add comments Signed-off-by: NAlex Deucher <alexdeucher@gmail.com> Cc: stable <stable@kernel.org> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
- 09 4月, 2010 22 次提交
-
-
由 Dave Airlie 提交于
* 'nouveau/for-airlied' of ../drm-nouveau-next: (21 commits) drm/nouveau: bail out of auxch transaction if we repeatedly recieve defers drm/nv50: implement gpio set/get routines drm/nv50: parse/use some more de-magiced parts of gpio table entries drm/nouveau: store raw gpio table entry in bios gpio structs drm/nv40: Init some tiling-related PGRAPH state. drm/nv50: Add NVA3 support in ctxprog/ctxvals generator. drm/nv50: another dodgy DP hack drm/nv50: punt hotplug irq handling out to workqueue drm/nv50: preserve an unknown SOR_MODECTRL value for DP encoders drm/nv50: Allow using the NVA3 new compute class. drm/nv50: cleanup properly if PDISPLAY init fails drm/nouveau: fixup the init failure paths some more drm/nv50: fix instmem init on IGPs if stolen mem crosses 4GiB mark drm/nv40: add LVDS table quirk for Dell Latitude D620 drm/nv40: rework lvds table parsing drm/nouveau: detect vram amount once, and save the value drm/nouveau: remove some unused members from drm_nouveau_private drm/nouveau: Make use of TTM busy_placements. drm/nv50: add more 0x100c80 flushy magic drm/nv50: fix fbcon when framebuffer above 4GiB mark ...
-
由 Ben Skeggs 提交于
There's one known case where we never stop recieving DEFER, and loop here forever. Lets not do that.. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
And use our own version of the GPIO table for the INIT_GPIO opcode. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Francisco Jerez 提交于
Fixes garbled 3D on an nv46 card. Reported-by: NFrancesco Marella <francesco.marella@gmail.com> Signed-off-by: NFrancisco Jerez <currojerez@riseup.net> Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Marcin Kościelnicki 提交于
Signed-off-by: NMarcin Kościelnicki <koriakin@0x04.net> Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Allows *some* DP cards to keep working in some corner cases that most people shouldn't hit. I hit it all the time with development, so this can stay for now. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
On DP outputs we'll likely end up running vbios init tables here, which may sleep. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
This value interacts with some registers we don't currently know how to program properly ourselves. The default of 5 that we were using matches what the VBIOS on early DP cards do, but later ones use 6, which would cause nouveau to program an incorrect mode on these chips. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Marcin Kościelnicki 提交于
Signed-off-by: NMarcin Kościelnicki <koriakin@0x04.net> Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Should fix: https://bugzilla.redhat.com/show_bug.cgi?id=505132 https://bugzilla.redhat.com/show_bug.cgi?id=543091 https://bugzilla.redhat.com/show_bug.cgi?id=530425 https://bugs.edge.launchpad.net/ubuntu/+source/xserver-xorg-video-nouveau/ +bug/539730 Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
All indications seem to be that the version 0x30 table should be handled the same way as 0x40 (as used on G80), at least for the parts that we currently try use. This commit cleans up the parsing to make it clearer about what we're actually trying to achieve, and unifies the 0x30/0x40 parsing. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
As opposed to repeatedly reading the amount back from the GPU every time we need to know the VRAM size. We should now fail to load gracefully on detecting no VRAM, rather than something potentially messy happening. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Francisco Jerez 提交于
Previously we were filling it the same as "placements", but in some cases there're valid alternatives that we were ignoring completely. Keeping a back-up memory type helps on several low-mem situations. Signed-off-by: NFrancisco Jerez <currojerez@riseup.net> Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Fixes the !vbo_fifo path in the 3D driver on certain chipsets. Still not really any good idea of what exactly the magic achieves, but it makes things work. While we're at it, in the PCIEGART path, flush on unbinding also. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
This can't actually happen right now, but lets fix it anyway. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Marcin Kościelnicki 提交于
Signed-off-by: NMarcin Kościelnicki <koriakin@0x04.net> Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-