- 27 1月, 2007 1 次提交
-
-
由 H. Peter Anvin 提交于
Add an official boot loader ID for Gujin. Signed-off-by: NH. Peter Anvin <hpa@zytor.com> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
- 07 12月, 2006 2 次提交
-
-
由 Vivek Goyal 提交于
Correct the documentation for bzImage protocol extension due to relocatable bzImage. Signed-off-by: NVivek Goyal <vgoyal@in.ibm.com> Signed-off-by: NAndi Kleen <ak@suse.de> Cc: Andi Kleen <ak@suse.de> Acked-by: N"H. Peter Anvin" <hpa@zytor.com> Signed-off-by: NAndrew Morton <akpm@osdl.org>
-
由 Vivek Goyal 提交于
Extend bzImage protocol to enable bootloaders to load a completely relocatable bzImage. Now protected mode component of kernel is also relocatable and a boot-loader can load the protected mode component at a differnt physical address than 1MB. (If kernel was built with CONFIG_RELOCATABLE) Kexec can make use of it to load this kernel at a different physical address to capture kernel crash dumps. Signed-off-by: NVivek Goyal <vgoyal@in.ibm.com> Signed-off-by: NAndi Kleen <ak@suse.de> Cc: Andi Kleen <ak@suse.de> Signed-off-by: NAndrew Morton <akpm@osdl.org>
-
- 13 9月, 2006 1 次提交
-
-
由 Jeremy Fitzhardinge 提交于
Claim an ID number for Xen in the LOADER_TYPE field. Also, keep the table in zero-page.txt consistent with boot.txt. [hpa says: 6 was skipped because I couldn't rule out that it hadn't been unofficially used. It seemed easier to skip it for now.] Signed-off-by: NJeremy Fitzhardinge <jeremy@xensource.com> Acked-by: N"H. Peter Anvin" <hpa@zytor.com> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 08 9月, 2005 1 次提交
-
-
由 H. Peter Anvin 提交于
Signed-off-by: NH. Peter Anvin <hpa@zytor.com> Cc: Frank Sorenson <frank@tuxrocks.com> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 01 5月, 2005 1 次提交
-
-
由 Venkatesh Pallipadi 提交于
The specifications that talk about E820 map doesn't have an upper limit on the number of e820 entries. But, today's kernel has a hard limit of 32. With increase in memory size, we are seeing the number of E820 entries reaching close to 32. Patch below bumps the number upto 128. The patch changes the location of EDDBUF in zero-page (as it comes after E820). As, EDDBUF is not used by boot loaders, this patch should not have any effect on bootloader-setup code interface. Patch covers both i386 and x86-64. Tested on: * grub booting bzImage * lilo booting bzImage with EDID info enabled * pxeboot of bzImage Side-effect: bss increases by ~ 2K and init.data increases by ~7.5K on all systems, due to increase in size of static arrays. Signed-off-by: NVenkatesh Pallipadi <venkatesh.pallipadi@intel.com> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 17 4月, 2005 1 次提交
-
-
由 Linus Torvalds 提交于
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
-