Skip to content

K
Kernel

openeuler / Kernel
1 年多 前同步成功

通知 8
Star 0
Fork 0
K
Kernel
切换分支/标签
  1. 28 9月, 2006 2 次提交
    • T
      [GFS2] inode_diet: Replace inode.u.generic_ip with inode.i_private (gfs) · bba9dfd8
      由 Theodore Ts'o 提交于 
      The following patches reduce the size of the VFS inode structure by 28 bytes
on a UP x86.  (It would be more on an x86_64 system).  This is a 10% reduction
in the inode size on a UP kernel that is configured in a production mode
(i.e., with no spinlock or other debugging functions enabled; if you want to
save memory taken up by in-core inodes, the first thing you should do is
disable the debugging options; they are responsible for a huge amount of bloat
in the VFS inode structure).

This patch:

The filesystem or device-specific pointer in the inode is inside a union,
which is pretty pointless given that all 30+ users of this field have been
using the void pointer.  Get rid of the union and rename it to i_private, with
a comment to explain who is allowed to use the void pointer.  This is just a
cleanup, but it allows us to reuse the union 'u' for something something where
the union will actually be used.
Signed-off-by: N"Theodore Ts'o" <tytso@mit.edu>
Cc: Steven Whitehouse <swhiteho@redhat.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
      bba9dfd8
    • S
      [GFS2] Fix bug in Makefiles for lock modules · 7e18c02b
      由 Steven Whitehouse 提交于 
      The Makefile had the wrong CONFIG_ variable in it so that in
case GFS2 was y and the lock modules were m, they were not
getting built properly.
Signed-off-by: NSteven Whitehouse <swhiteho@redhat.com>
      7e18c02b
  3. 27 9月, 2006 32 次提交
  5. 26 9月, 2006 6 次提交
    • A
      [PATCH] binfmt_elf: consistently use loff_t · 8d6b5eee
      由 Andrew Morton 提交于 
      As David Howells <dhowells@redhat.com> points out, binfmt_elf sometimes uses
off_t, sometimes uses loff_t.  Use loff_t throughout.
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
      8d6b5eee
    • C
      [PATCH] ZVC: Support NR_SLAB_RECLAIMABLE / NR_SLAB_UNRECLAIMABLE · 972d1a7b
      由 Christoph Lameter 提交于 
      Remove the atomic counter for slab_reclaim_pages and replace the counter
and NR_SLAB with two ZVC counter that account for unreclaimable and
reclaimable slab pages: NR_SLAB_RECLAIMABLE and NR_SLAB_UNRECLAIMABLE.

Change the check in vmscan.c to refer to to NR_SLAB_RECLAIMABLE.  The
intend seems to be to check for slab pages that could be freed.
Signed-off-by: NChristoph Lameter <clameter@sgi.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
      972d1a7b
    • C
      [PATCH] reduce MAX_NR_ZONES: make display of highmem counters conditional on CONFIG_HIGHMEM · 182e8e23
      由 Christoph Lameter 提交于 
      Do not display HIGHMEM memory sizes if CONFIG_HIGHMEM is not set.

Make HIGHMEM dependent texts and make display of highmem counters optional

Some texts are depending on CONFIG_HIGHMEM.

Remove those strings and remove the display of highmem counter values if
CONFIG_HIGHMEM is not set.

[akpm@osdl.org: remove some ifdefs]
Signed-off-by: NChristoph Lameter <clameter@sgi.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
      182e8e23
    • P
      [PATCH] mm: tracking shared dirty pages · d08b3851
      由 Peter Zijlstra 提交于 
      Tracking of dirty pages in shared writeable mmap()s.

The idea is simple: write protect clean shared writeable pages, catch the
write-fault, make writeable and set dirty.  On page write-back clean all the
PTE dirty bits and write protect them once again.

The implementation is a tad harder, mainly because the default
backing_dev_info capabilities were too loosely maintained.  Hence it is not
enough to test the backing_dev_info for cap_account_dirty.

The current heuristic is as follows, a VMA is eligible when:
 - its shared writeable
    (vm_flags & (VM_WRITE|VM_SHARED)) == (VM_WRITE|VM_SHARED)
 - it is not a 'special' mapping
    (vm_flags & (VM_PFNMAP|VM_INSERTPAGE)) == 0
 - the backing_dev_info is cap_account_dirty
    mapping_cap_account_dirty(vma->vm_file->f_mapping)
 - f_op->mmap() didn't change the default page protection

Page from remap_pfn_range() are explicitly excluded because their COW
semantics are already horrid enough (see vm_normal_page() in do_wp_page()) and
because they don't have a backing store anyway.

mprotect() is taught about the new behaviour as well.  However it overrides
the last condition.

Cleaning the pages on write-back is done with page_mkclean() a new rmap call.
It can be called on any page, but is currently only implemented for mapped
pages, if the page is found the be of a VMA that accounts dirty pages it will
also wrprotect the PTE.

Finally, in fs/buffers.c:try_to_free_buffers(); remove clear_page_dirty() from
under ->private_lock.  This seems to be safe, since ->private_lock is used to
serialize access to the buffers, not the page itself.  This is needed because
clear_page_dirty() will call into page_mkclean() and would thereby violate
locking order.

[dhowells@redhat.com: Provide a page_mkclean() implementation for NOMMU]
Signed-off-by: NPeter Zijlstra <a.p.zijlstra@chello.nl>
Cc: Hugh Dickins <hugh@veritas.com>
Signed-off-by: NDavid Howells <dhowells@redhat.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
      d08b3851
    • J
      [PATCH] jbd: fix commit of ordered data buffers · 3998b930
      由 Jan Kara 提交于 
      Original commit code assumes, that when a buffer on BJ_SyncData list is
locked, it is being written to disk.  But this is not true and hence it can
lead to a potential data loss on crash.  Also the code didn't count with
the fact that journal_dirty_data() can steal buffers from committing
transaction and hence could write buffers that no longer belong to the
committing transaction.  Finally it could possibly happen that we tried
writing out one buffer several times.

The patch below tries to solve these problems by a complete rewrite of the
data commit code.  We go through buffers on t_sync_datalist, lock buffers
needing write out and store them in an array.  Buffers are also immediately
refiled to BJ_Locked list or unfiled (if the write out is completed).  When
the array is full or we have to block on buffer lock, we submit all
accumulated buffers for IO.

[suitable for 2.6.18.x around the 2.6.19-rc2 timeframe]
Signed-off-by: NJan Kara <jack@suse.cz>
Cc: Badari Pulavarty <pbadari@us.ibm.com>
Cc: <stable@kernel.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
      3998b930
    • A
      [PATCH] Check return value of copy_to_user in compat_sys_pselect7 · 75833345
      由 Andi Kleen 提交于 
      Fix

linux/fs/compat.c: In function compat_sys_pselect7
linux/fs/compat.c:1869: warning: ignoring return value of copy_to_user, declared with attribute warn_unused_result

To make it easier to handle I changed to semantics to not try to
write out a timespec if an error occurred. I hope that's ok.

Cc: dwmw2@infradead.org
Signed-off-by: NAndi Kleen <ak@suse.de>
      75833345