You need to sign in or sign up before continuing.
  1. 07 2月, 2009 5 次提交
    • D
      net_dma: call dmaengine_get only if NET_DMA enabled · b4bd07c2
      David S. Miller 提交于
      Based upon a patch from Atsushi Nemoto <anemo@mba.ocn.ne.jp>
      
      --------------------
      The commit 649274d9 ("net_dma:
      acquire/release dma channels on ifup/ifdown") added unconditional call
      of dmaengine_get() to net_dma.  The API should be called only if
      NET_DMA was enabled.
      --------------------
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      Acked-by: NDan Williams <dan.j.williams@intel.com>
      b4bd07c2
    • O
      3c509: Fix resume from hibernation for PnP mode. · 152abd13
      Ondrej Zary 提交于
      From: Ondrej Zary <linux@rainbow-software.org>
      
      last year, I posted a patch which fixed hibernation on 3c509
      cards. That was back in 2.6.24. It worked fine in 2.6.25. But then I
      stopped using hibernation (as it did not work with my new IT8212 RAID
      controller).
      
      Now I fixed it and noticed that 3c509 does not wake up properly
      anymore (in 2.6.28) - neither in PnP nor in ISA modes. ifconfig
      down/up makes the card work again in PnP mode. However, in ISA mode,
      ifconfig up ends with "No such device" error.
      
      Comparing the 3c509 driver between 2.6.25 and 2.6.28, there's only
      some statistics-related change. So the cause of the problem must be
      somewhere else.
      
      This patch makes the resume work in PnP mode, but it's still not
      enough for ISA mode.
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      152abd13
    • I
      sungem: Soft lockup in sungem on Netra AC200 when switching interface up · 71822faa
      Ilkka Virta 提交于
      From: Ilkka Virta <itvirta@iki.fi>
      
      In the lockup situation the driver seems to go off in an eternal storm
      of interrupts right after calling request_irq(). It doesn't actually
      do anything interesting in the interrupt handler. Since connecting the link
      afterwards works, something later in initialization must fix this.
      
      Looking at gem_do_start() and gem_open(), it seems that the only thing
      done while opening the device after the request_irq(), is a call to
      napi_enable().
      
      I don't know what the ordering requirements are for the
      initialization, but I boldly tried to move the napi_enable() call
      inside gem_do_start() before the link state is checked and interrupts
      subsequently enabled, and it seems to work for me. Doesn't even break
      anything too obvious...
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      71822faa
    • D
      RxRPC: Fix a potential NULL dereference · 15bde727
      David Howells 提交于
      Fix a potential NULL dereference bug during error handling in
      rxrpc_kernel_begin_call(), whereby rxrpc_put_transport() may be handed a NULL
      pointer.
      
      This was found with a code checker (http://repo.or.cz/w/smatch.git/).
      Reported-by: NDan Carpenter <error27@gmail.com>
      Signed-off-by: NDavid Howells <dhowells@redhat.com>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      15bde727
    • I
      r8169: Don't update statistics counters when interface is down · 355423d0
      Ivan Vecera 提交于
      Some Realtek chips (RTL8169sb/8110sb in my case) are unable to retrieve
      ethtool statistics when the interface is down. The process stays in
      endless loop in rtl8169_get_ethtool_stats. This is because these chips
      need to have receiver enabled (CmdRxEnb bit in ChipCmd register) that is
      cleared when the interface is going down. It's better to update statistics
      only when the interface is up and otherwise return copy of statistics
      grabbed when the interface was up (in rtl8169_close).
      
      It is interesting that PCI-E NICs (like 8168b/8111b...) are not affected.
      Signed-off-by: NIvan Vecera <ivecera@redhat.com>
      Acked-by: NFrancois Romieu <romieu@fr.zoreil.com>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      355423d0
  2. 06 2月, 2009 7 次提交
  3. 05 2月, 2009 5 次提交
    • A
      gianfar: Fix potential soft reset race · b98ac702
      Andy Fleming 提交于
      SOFT_RESET must be asserted for at least 3 TX clocks in order for it to work
      properly.  The syncs in the gfar_write() commands have been hiding this, but
      we need to guarantee it.
      Signed-off-by: NAndy Fleming <afleming@freescale.com>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      b98ac702
    • A
      gianfar: Fix BD_LENGTH_MASK definition · 1fbe4932
      Andy Fleming 提交于
      BD_LENGTH_MASK is supposed to catch the low 16-bits of the status field, not
      the low byte.  The old way, we would never be able to clean up tx packets with
      sizes divisible by 256.
      Signed-off-by: NAndy Fleming <afleming@freescale.com>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      1fbe4932
    • D
      cxgb3: Fix lro switch · 65ab8385
      Divy Le Ray 提交于
      The LRO switch is always set to 1 in the rx processing loop.
      It breaks the accelerated iSCSI receive traffic.
      Fix its computation.
      Signed-off-by: NDivy Le Ray <divy@chelsio.com>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      65ab8385
    • R
      iwlwifi: save PCI state before suspend, restore after resume · c4e061ac
      Reinette Chatre 提交于
      This is the right thing to do and fixes the following warning:
      
      [  115.012278] ------------[ cut here ]------------
      [  115.012281] WARNING: at drivers/pci/pci-driver.c:370
      pci_legacy_suspend+0x85/0xc2()
      [  115.012285] Hardware name: Latitude D630
      [  115.012301] PCI PM: Device state not saved by
      iwl3945_pci_suspend+0x0/0x4c [iwl3945]
      [  115.012304] Modules linked in: fuse nfsd lockd nfs_acl auth_rpcgss
      exportfs sunrpc ipv6 acpi_cpufreq kvm_intel kvm snd_hda_codec_idt
      snd_hda_intel snd_hda_codec snd_hwdep arc4 snd_seq_device snd_pcm_oss
      snd_mixer_oss ecb snd_pcm cryptomgr aead snd_timer crypto_blkcipher
      snd snd_page_alloc ohci1394 crypto_hash crypto_algapi ch341 ieee1394
      usbserial thermal iwl3945 mac80211 led_class lib80211 tg3 processor
      i2c_i801 i2c_core sg cfg80211 libphy usbhid battery ac button sr_mod
      cdrom evdev dcdbas ata_generic ata_piix libata sd_mod scsi_mod ext3
      jbd mbcache uhci_hcd ohci_hcd ehci_hcd usbcore [last unloaded:
      microcode]
      [  115.012374] Pid: 4163, comm: pm-suspend Not tainted
      2.6.29-rc3-00227-gf1dd849-dirty #67
      [  115.012377] Call Trace:
      [  115.012382]  [<ffffffff8023d04d>] warn_slowpath+0xb1/0xed
      [  115.012387]  [<ffffffff80450b5e>] ? _spin_unlock_irqrestore+0x5c/0x78
      [  115.012390]  [<ffffffff80254f08>] ? up+0x34/0x39
      [  115.012394]  [<ffffffff80362319>] ? acpi_ut_release_mutex+0x5d/0x61
      [  115.012397]  [<ffffffff803584b2>] ? acpi_get_data+0x5e/0x70
      [  115.012400]  [<ffffffff80363dd9>] ? acpi_bus_get_device+0x25/0x39
      [  115.012403]  [<ffffffff80363e98>] ? acpi_bus_power_manageable+0x11/0x29
      [  115.012406]  [<ffffffff803462f7>] ? acpi_pci_power_manageable+0x17/0x19
      [  115.012410]  [<ffffffff8033ddfd>] ? pci_set_power_state+0xcc/0x101
      [  115.012418]  [<ffffffffa01f28e9>] ? iwl3945_pci_suspend+0x0/0x4c [iwl3945]
      [  115.012422]  [<ffffffff803401e6>] pci_legacy_suspend+0x85/0xc2
      [  115.012425]  [<ffffffff80340316>] pci_pm_suspend+0x34/0x86
      [  115.012429]  [<ffffffff8039d7ce>] pm_op+0x52/0xe5
      [  115.012432]  [<ffffffff8039dd78>] device_suspend+0x32a/0x451
      [  115.012436]  [<ffffffff80269ec2>] suspend_devices_and_enter+0x3e/0x13a
      [  115.012439]  [<ffffffff8026a128>] enter_state+0x110/0x164
      [  115.012442]  [<ffffffff8026a233>] state_store+0xb7/0xd7
      [  115.012446]  [<ffffffff8032f95f>] kobj_attr_store+0x17/0x19
      [  115.012449]  [<ffffffff80307d64>] sysfs_write_file+0xe4/0x119
      [  115.012453]  [<ffffffff802baa7a>] vfs_write+0xae/0x137
      [  115.012456]  [<ffffffff802babc7>] sys_write+0x47/0x70
      [  115.012459]  [<ffffffff8020b73a>] system_call_fastpath+0x16/0x1b
      [  115.012467] ---[ end trace 829828966f6f24dc ]---
      Signed-off-by: NReinette Chatre <reinette.chatre@intel.com>
      Tested-by: NMing Lei <tom.leiming@gmail.com>
      Cc: Rafael J. Wysocki <rjw@sisk.pl>
      Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
      c4e061ac
    • R
      iwlwifi: clean key table in iwl_clear_stations_table · 5e46882e
      Reinette Chatre 提交于
      Cleans uCode key table bit map iwl_clear_stations_table
      since all stations are cleared also the key table must be.
      
      Since the keys are not removed properly on suspend by mac80211
      this may result in exhausting key table on resume leading
      to memory corruption during removal
      Signed-off-by: NTomas Winkler <tomas.winkler@intel.com>
      Signed-off-by: NReinette Chatre <reinette.chatre@intel.com>
      Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
      5e46882e
  4. 04 2月, 2009 5 次提交
  5. 03 2月, 2009 18 次提交