1. 17 7月, 2008 1 次提交
    • B
      PNP: replace pnp_resource_table with dynamically allocated resources · aee3ad81
      Bjorn Helgaas 提交于
      PNP used to have a fixed-size pnp_resource_table for tracking the
      resources used by a device.  This table often overflowed, so we've
      had to increase the table size, which wastes memory because most
      devices have very few resources.
      
      This patch replaces the table with a linked list of resources where
      the entries are allocated on demand.
      
      This removes messages like these:
      
          pnpacpi: exceeded the max number of IO resources
          00:01: too many I/O port resources
      
      References:
      
          http://bugzilla.kernel.org/show_bug.cgi?id=9535
          http://bugzilla.kernel.org/show_bug.cgi?id=9740
          http://lkml.org/lkml/2007/11/30/110
      
      This patch also changes the way PNP uses the IORESOURCE_UNSET,
      IORESOURCE_AUTO, and IORESOURCE_DISABLED flags.
      
      Prior to this patch, the pnp_resource_table entries used the flags
      like this:
      
          IORESOURCE_UNSET
      	This table entry is unused and available for use.  When this flag
      	is set, we shouldn't look at anything else in the resource structure.
      	This flag is set when a resource table entry is initialized.
      
          IORESOURCE_AUTO
      	This resource was assigned automatically by pnp_assign_{io,mem,etc}().
      
      	This flag is set when a resource table entry is initialized and
      	cleared whenever we discover a resource setting by reading an ISAPNP
      	config register, parsing a PNPBIOS resource data stream, parsing an
      	ACPI _CRS list, or interpreting a sysfs "set" command.
      
      	Resources marked IORESOURCE_AUTO are reinitialized and marked as
      	IORESOURCE_UNSET by pnp_clean_resource_table() in these cases:
      
      	    - before we attempt to assign resources automatically,
      	    - if we fail to assign resources automatically,
      	    - after disabling a device
      
          IORESOURCE_DISABLED
      	Set by pnp_assign_{io,mem,etc}() when automatic assignment fails.
      	Also set by PNPBIOS and PNPACPI for:
      
      	    - invalid IRQs or GSI registration failures
      	    - invalid DMA channels
      	    - I/O ports above 0x10000
      	    - mem ranges with negative length
      
      After this patch, there is no pnp_resource_table, and the resource list
      entries use the flags like this:
      
          IORESOURCE_UNSET
      	This flag is no longer used in PNP.  Instead of keeping
      	IORESOURCE_UNSET entries in the resource list, we remove
      	entries from the list and free them.
      
          IORESOURCE_AUTO
      	No change in meaning: it still means the resource was assigned
      	automatically by pnp_assign_{port,mem,etc}(), but these functions
      	now set the bit explicitly.
      
      	We still "clean" a device's resource list in the same places,
      	but rather than reinitializing IORESOURCE_AUTO entries, we
      	just remove them from the list.
      
      	Note that IORESOURCE_AUTO entries are always at the end of the
      	list, so removing them doesn't reorder other list entries.
      	This is because non-IORESOURCE_AUTO entries are added by the
      	ISAPNP, PNPBIOS, or PNPACPI "get resources" methods and by the
      	sysfs "set" command.  In each of these cases, we completely free
      	the resource list first.
      
          IORESOURCE_DISABLED
      	In addition to the cases where we used to set this flag, ISAPNP now
      	adds an IORESOURCE_DISABLED resource when it reads a configuration
      	register with a "disabled" value.
      Signed-off-by: NBjorn Helgaas <bjorn.helgaas@hp.com>
      Signed-off-by: NLen Brown <len.brown@intel.com>
      Signed-off-by: NAndi Kleen <ak@linux.intel.com>
      aee3ad81
  2. 01 5月, 2008 1 次提交
  3. 29 4月, 2008 15 次提交
  4. 07 2月, 2008 1 次提交
  5. 24 8月, 2007 1 次提交
  6. 27 7月, 2007 2 次提交
  7. 12 2月, 2007 1 次提交
  8. 14 12月, 2006 1 次提交
  9. 01 7月, 2006 1 次提交
  10. 23 3月, 2006 1 次提交
  11. 31 10月, 2005 1 次提交
    • T
      [PATCH] fix missing includes · 4e57b681
      Tim Schmielau 提交于
      I recently picked up my older work to remove unnecessary #includes of
      sched.h, starting from a patch by Dave Jones to not include sched.h
      from module.h. This reduces the number of indirect includes of sched.h
      by ~300. Another ~400 pointless direct includes can be removed after
      this disentangling (patch to follow later).
      However, quite a few indirect includes need to be fixed up for this.
      
      In order to feed the patches through -mm with as little disturbance as
      possible, I've split out the fixes I accumulated up to now (complete for
      i386 and x86_64, more archs to follow later) and post them before the real
      patch.  This way this large part of the patch is kept simple with only
      adding #includes, and all hunks are independent of each other.  So if any
      hunk rejects or gets in the way of other patches, just drop it.  My scripts
      will pick it up again in the next round.
      Signed-off-by: NTim Schmielau <tim@physik3.uni-rostock.de>
      Signed-off-by: NAndrew Morton <akpm@osdl.org>
      Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
      4e57b681
  12. 08 9月, 2005 1 次提交
  13. 28 7月, 2005 1 次提交
  14. 12 7月, 2005 1 次提交
  15. 01 5月, 2005 1 次提交
  16. 17 4月, 2005 1 次提交
    • L
      Linux-2.6.12-rc2 · 1da177e4
      Linus Torvalds 提交于
      Initial git repository build. I'm not bothering with the full history,
      even though we have it. We can create a separate "historical" git
      archive of that later if we want to, and in the meantime it's about
      3.2GB when imported into git - space that would just make the early
      git days unnecessarily complicated, when we don't have a lot of good
      infrastructure for it.
      
      Let it rip!
      1da177e4