- 24 7月, 2012 32 次提交
-
-
由 Scott Jiang 提交于
PPI driver has changed blank units from clocks to pixels. Signed-off-by: NScott Jiang <scott.jiang.linux@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Bob Liu 提交于
Musb can't work since the marco name has been changed. Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Add pint suspend and resume if defined BFIN_GPIO_PINT. Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
save and restore pint sec CTL save and restore pint registers add pint suspend and resume when suspend to mem Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Scott Jiang 提交于
Signed-off-by: NScott Jiang <scott.jiang.linux@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Scott Jiang 提交于
Signed-off-by: NScott Jiang <scott.jiang.linux@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Pass wake up source mask and wakeup source polarity to deepsleep and hibernate. Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Bob Liu 提交于
Set .probe_type = "map_rom" for norflash so that xip_test can run correctly. Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Sonic Zhang 提交于
Otherwise, the compiler may optimize assemble code into 8bit access instruction when target register is 8 bit width. Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Scott Jiang 提交于
Signed-off-by: NScott Jiang <scott.jiang.linux@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Bob Liu 提交于
Add irq_set_wake to bfin_sec_irqchip, drivers like stmmac need it. Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Scott Jiang 提交于
Signed-off-by: NScott Jiang <scott.jiang.linux@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Sonic Zhang 提交于
Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Sonic Zhang 提交于
Add add deepsleep for bf60x. 1. Call DMC init functions to enter and exit DDR self refresh mode. 2. Wait till CGU PLL is locked after wake up and exit DDR self refresh mode. 3. Make asessembly function enter_deepsleep comply with C funtion ABI in order to call other C functions. 4. Switch kernel stack by register EX_SCRATCH_REG. Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Bob Liu 提交于
ROM range of bf60x is above 0xb0000000. Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Bob Liu 提交于
So that user can set the clocks through menuconfig. Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Sonic Zhang 提交于
Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Steven Miao 提交于
Signed-off-by: NSteven Miao <realmz6@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Sonic Zhang 提交于
Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Sonic Zhang 提交于
Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Sonic Zhang 提交于
Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Sonic Zhang 提交于
Otherwise, chained sg list may be missed. Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Scott Jiang 提交于
We need larger DMA region to support HD video. Signed-off-by: NScott Jiang <scott.jiang.linux@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
由 Scott Jiang 提交于
Extend chip select number supported by spi master as well because we can accept SPISEL1-SPISEL7 and all GPIO. Signed-off-by: NScott Jiang <scott.jiang.linux@gmail.com> Signed-off-by: NBob Liu <lliubbo@gmail.com>
-
- 22 7月, 2012 7 次提交
-
-
由 Linus Torvalds 提交于
-
由 Rafael J. Wysocki 提交于
The SYSTEM_SUSPEND_DISK system state is never used, so drop it. Signed-off-by: NRafael J. Wysocki <rjw@sisk.pl> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
由 Linus Torvalds 提交于
Merge emailed kgdb dmesg fixups patches from Anton Vorontsov: "The dmesg command appears to be broken after the printk rework. The old logic in the kdb code makes no sense in terms of current printk/logging storage format, and KDB simply hangs forever upon entering 'dmesg' command. The first patch revives the command by switching to kmsg_dumper iterator. As a side-effect, the code is now much more simpler. A few changes were needed in the printk.c: we needed unlocked variant of the kmsg_dumper iterator, but these can surely wait for 3.6. It's probably too late even for the first patch to go to 3.5, but I'll try to convince otherwise. :-) Here we go: - The current code is broken for sure, and has no hope to work at all. It is a regression - The new code works for me, and probably works for everyone else; - If it compiles (and I urge everyone to compile-test it on your setup), it hardly can make things worse." * Merge emailed patches from Anton Vorontsov: (4 commits) kdb: Switch to nolock variants of kmsg_dump functions printk: Implement some unlocked kmsg_dump functions printk: Remove kdb_syslog_data kdb: Revive dmesg command
-
由 Anton Vorontsov 提交于
The locked variants are prone to deadlocks (suppose we got to the debugger w/ the logbuf lock held), so let's switch to nolock variants. Signed-off-by: NAnton Vorontsov <anton.vorontsov@linaro.org> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
由 Anton Vorontsov 提交于
If used from KDB, the locked variants are prone to deadlocks (suppose we got to the debugger w/ the logbuf lock held). So, we have to implement a few routines that grab no logbuf lock. Yet we don't need these functions in modules, so we don't export them. Signed-off-by: NAnton Vorontsov <anton.vorontsov@linaro.org> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
由 Anton Vorontsov 提交于
The function is no longer needed, so remove it. Signed-off-by: NAnton Vorontsov <anton.vorontsov@linaro.org> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
由 Anton Vorontsov 提交于
The kgdb dmesg command is broken after the printk rework. The old logic in kdb code makes no sense in terms of current printk/logging storage format, and KDB simply hangs forever. This patch revives the command by switching to kmsg_dumper iterator. The code is now much more simpler and shorter. Signed-off-by: NAnton Vorontsov <anton.vorontsov@linaro.org> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
- 21 7月, 2012 1 次提交
-
-
git://git.linux-mips.org/pub/scm/ralf/upstream-linus由 Linus Torvalds 提交于
Pull late MIPS fixes from Ralf Baechle: "This fixes a number of lose ends in the MIPS code and various bug fixes. Aside of dropping some patch that should not be in this pull request everything has sat in -next for quite a while and there are no known issues. The biggest patch in this patch set moves the allocation of an array that is aliased to a function (for runtime generated code) to assembler code. This avoids an issue with certain toolchains when building for microMIPS." * 'upstream' of git://git.linux-mips.org/pub/scm/ralf/upstream-linus: (35 commits) MIPS: PCI: Move fixups from __init to __devinit. MIPS: Fix bug.h MIPS build regression MIPS: sync-r4k: remove redundant irq operation MIPS: smp: Warn on too early irq enable MIPS: call set_cpu_online() on cpu being brought up with irq disabled MIPS: call ->smp_finish() a little late MIPS: Yosemite: delay irq enable to ->smp_finish() MIPS: SMTC: delay irq enable to ->smp_finish() MIPS: BMIPS: delay irq enable to ->smp_finish() MIPS: Octeon: delay enable irq to ->smp_finish() MIPS: Oprofile: Fix build as a module. MIPS: BCM63XX: Fix BCM6368 IPSec clock bit MIPS: perf: Fix build error caused by unused counters_per_cpu_to_total() MIPS: Fix Magic SysRq L kernel crash. MIPS: BMIPS: Fix duplicate header inclusion. mips: mark const init data with __initconst instead of __initdata MIPS: cmpxchg.h: Add missing include MIPS: Malta may also be equipped with MIPS64 R2 processors. MIPS: Fix typo multipy -> multiply MIPS: Cavium: Fix duplicate ARCH_SPARSEMEM_ENABLE in kconfig. ...
-