Add mode 6 support to the sh_keysc driver. Also update the KYOUTDR mask
value to include all 16 register bits.
Signed-off-by: NMagnus Damm <damm@opensource.se>
Signed-off-by: NDmitry Torokhov <dtor@mail.ru>

Add Mode 4 and Mode 5 support to the SH_KEYSC driver. These modes allow
slightly larger key pad matrixes.

While at it, make use of resource_size().
Signed-off-by: NMagnus Damm <damm@opensource.se>
Signed-off-by: NDmitry Torokhov <dtor@mail.ru>

This patch moves the KEYSC header file from the
SuperH specific asm directory to a place where
it can be shared by multiple architectures.
Signed-off-by: NMagnus Damm <damm@opensource.se>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

After KYCR2 is set, udelay might become necessary if there are only a
small number of keys attached. This patch introduces an optional delay
through the platform data to address this problem.
Signed-off-by: NKuninori Morimoto <morimoto.kuninori@renesas.com>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

This follows the sparc changes a439fe51.

Most of the moving about was done with Sam's directions at:

http://marc.info/?l=linux-sh&m=121724823706062&w=2

with subsequent hacking and fixups entirely my fault.
Signed-off-by: NSam Ravnborg <sam@ravnborg.org>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

Add a platform driver for the SuperH KEYSC block.  The driver expects to get
mode, timing information and keypad layout from the board code as platform
data.  The board code is resonsible for pin configuration.

Both sh7343 and sh7722 should be supported, but only the sh7722 processor has
been tested so far.  SH_KEYSC_MODE_3 is yet to be tested.
Signed-off-by: NMagnus Damm <damm@igel.co.jp>
Cc: Dmitry Torokhov <dtor@mail.ru>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>